RX401-16 Datasheet, PDF (4/7 Pages) NTE Electronics – MATERIAL SAFETY DATA SHEET

Ethyl Hydroxy Propionate
TWA [²]
STEL
[3]
1,1,1,2 – Tetraflouroethane (HFC – 134a) TWA NE
NE
1,000 [4]
OSHA TABLE COMMENTS:
1. NOT ESTABLISHED
2. NA=NOT APPLICABLE
3. NOT APPLICABLE
4. * (AEL) = Acceptable Exposure Limit as established by the manufacture
ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to
control airborne levels below recommended exposure limits.
PERSONAL PROTECTIVE EQUIPMENT
EYES AND FACE: For normal conditions, wear safety glasses. Where there is reasonable probability of liquid
contact, wear splash-proof goggles.
SKIN: The glove(s) listed below may provide protection against permeation. Gloves of other chemically resistant
materials may not provide adequate protection.
Viton, Solvex, Butyl, Buna, Neoprene.
RESPIRATORY: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements
must be followed whenever workplace conditions warrant a respirator’s use.
OTHER USE PRECAUTIONS: Emergency shower and eyewash facility should be in close proximity.
9. PHYSICAL AND CHEMICAL PROPERTIES
ORDOR: Faint ethereal odor
APPEARANCE: Clear, Colorless liquid
PERCENT VOLATILE: 100
VAPOR PRESSURE: 17.8 psi at 20˚ C (68˚ F)
EVAPORATION RATE: <1 (TCE=1)
SPECIFIC GRAVITY: 1.249 (water=1)
(VOC): 856.5 g/L (non exempt VOC)
10. STABILITY AND REACTIVITY
STABLE: YES
HAZARDOUS POLYMERIZATION: NO
CONDITIONS TO AVOID: Stable. However, may decompose if heated.
STABILITY: Stable.
POLYMERIZATION: Will not occur.
HAZARDOUS DECPMPOSITION PRODUCTS: May form hydrofluoric acids – possibly carbonyl halides, when
exposed to high temperatures.