RX1100-10 Datasheet, PDF (3/6 Pages) NTE Electronics – MATERIAL SAFETY DATA SHEET

MSDS Ref. No:RX1100-10,-12
COMMENTS: *Based on ASHRAE Standard 34 with match ignition.
6. ACCIDENTAL RELEASE MEASURES
GENERAL PROCEDURES: Isolate hazard area. Keep unnecessary and unprotected personnel from entering.
RELEASE NOTES: Spills and releases may have to be reported to Federal and/or local authorities.
7. HANDLING AND STORAGE
HANDLING: Follow standard safety precautions for handling and use of compressed gas cylinders.
STORAGE: Store in a cool place in original container and protect from sunlight.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
EXPOSURE GUIDELINES:
OSHA HAZARDOUS COMPONENTS (29 CFR 1910.1200)
EXPOSURE LIMITS
OSHA PEL ACGIH TLV Supplier OEL
ppm _mg/m³ ppm _mg/m³ ppm _mg/m³
1,1,1,2-Tetrafluoroethane (HFC-134a)
TWA NE
NE
1,000^[1]
OSHA TABLE COMMENTS:
1. * (AEL)=Acceptable Exposure Limit as established by the manufacture
ENGINEERING CONTROLS: Local exhaust ventilation may be necessary to control any air contaminants to
within their TLVs during the use of this product.
PERSONAL PROTECTIVE EQUIPMENT
EYES AND FACE: Wear safety glasses with side shields (or goggles) and a face shield.
SKIN: Skin contact with liquid may cause frostbite. General work clothing and gloves (leather) should provide
adequate protection. If prolonged contact with the liquid or gas is anticipated, insulated gloves constructed of
PVA, neoprene or butyl rubber should be used. Any contaminated clothing should be promptly removed and
washed before reuse.
RESPIRATORY: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements
must be followed whenever workplace conditions warrant a respirator's use.
9. PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE: Gas
ODOR: Faint ethereal odor
file:///N|/MSDS/86544q1e.htm (3 of 6)1/13/2004 12:02:23 PM