NTE303A Datasheet, PDF (3/5 Pages) NTE Electronics – Silicone Heat Sink Compound

Spill Mitigation Procedures (Cont’d)
Land Release:
Create a dike or trench to contain materials. Absorb spill with inert material (e.g., dry sand, clay, earth
or commercial absorbent), then place in a chemical waste container. Decontaminate all clothing and the
spill area using a detergent and flush with large amounts of water. Contain all contaminated water for
disposal and/or treatment.
Additional Spill Information:
Stop source of spill as soon as possible and notify appropriate personnel. Utilize emergency response
personal protection equipment prior to the start of any response. Evacuate all non-essential personnel.
Dispose of spill residues per guidelines under Section XIII, Disposal Considerations.
VII HANDLING AND STORAGE
Handling:
Do not take internally. Avoid contact with skin, eyes and clothing. Upon contact with skin or eyes, wash
with soap and water. Avoid breathing vapor or mist.
Storage
Keep container tightly closed. Store in a cool area away from ignition sources and oxidizers.
No special precautions need be taken if product is handled according to directions.
VIII EXPOSURE CONTROLS/ PERSONAL PROTECTION
Ventilation:
Local exhaust ventilation or other engineering controls are normally NOT necessary when handling or
using this product. General exhaust ventilation is usually sufficient for general worker safety and
comfort.
Explosion proof motors and fans are not required for unheated handling.
Respirator Type(s):
Air purifying respirators should not be used in oxygen deficient or IDLH atmospheres or if exposure
concentrations exceed ten (10) times the published limit.
Skin: Wear impervious gloves (butyl rubber, Viton, e.g.) to avoid skin contact. Follow good industrial hygiene
practices.
Eyes: Use chemical safety glasses with side shields, safety goggles and/or a full face shield where splashing
is possible.
Protective Clothing Type: Impervious
IX PHYSICAL AND CHEMICAL DATA
Physical State: Heavy grease
Color:
White
Odor:
Nil
Molecular Weight:
Not applicable to mixtures
pH (@ 25 Deg. C): Not applicable
Octanol/Water Coeff: No data
Solubility in Water: negligible
Bulk Density:
Not applicable
Specific Gravity (68 Deg.F): 2.2
Explosive limits:
No data. Low volatility makes ambient explosive
vapor concentrations impossible.
Vapor Density (Air = 1):
Vapor Pressure: (@ 20 Deg. C):
Evaporation Rate (Estimated):
Flash Point, (Estimated)
Volatiles % by vol.:
Approximate Boiling Point (deg.F):
Drop Point:
No data
<1
<1
> 400F
negligible
> 400
None