NTE1919 Datasheet, PDF (2/2 Pages) NTE Electronics – Integrated Circuit Negative 3 Terminal Voltage Regulator, -15V, 1.5A

Electrical Characteristics: (T_J = +25°C unless otherwise specified)
Parameter
Symbol
Test Conditions
Min Typ Max Unit
Output Voltage
V_O V_IN = –20V to –25V, I_O = 10mA to 1A, Note 2
14.05 15.0 16.05 V
Input–Output Differential V_IN–V_O I_O = 1A, T_J = 0 to +125°C
–2.1 –
–
V
Line Regulation
Reg_Line V_IN = –20V to –25V, I_O = 1A, Note 2
–
– 2.0 % V_O
Load Regulation
Reg_Load V_IN = –20V, I_O = 10mA to 1.5A, Note 2
–
– 0.6 % V_O
Quiescent Current
I_Q V_IN = –20V, I_O = 10mA
–
– 10
mA
Quiescent Current Line I_Q(Line) V_IN = –20V to –30V, I_O = 10mA
–
– 1.3
mA
Quiescent Current Load I_Q(Load) V_IN = –20V, I_O = 10mA to 1.5A
–
– 0.75 mA
Current Limit
I_LIM V_IN = –20V, Note 2
–
– 3.5
A
Temperature Coefficient T_C V_IN = –20V, I_O = 100mA, T_J = 0 to +125°C
–
– 0.03 % V_O/°C
Output Noise Voltage
V_N V_IN = –20V, I_O = 100mA. T_J = 0 to +125°C, Note 3 –
–
10 µV_rms/V
Ripple Attenuation
R_A V_IN = –20V, I_O = 1A, T_J = 0 to +125°C, Note 4
54 –
–
dB
Note 2. Low duty cycle pulse testing with Kelvin connections required. Die temperature changes
must be accounted for separatly.
Note 3. BW = 10Hz to 100kHz.
Note 4. Ripple attenuation is specified for a 1Vrms, 120Hz, input ripple. Ripple attenuation is mini-
mum of 60dB at 5V output and is 1dB less for each volt increase in the output voltage.
.350 (8.89)
.135 (3.45) Max
.875 (22.2)
Dia Max
Seating
Plane
.312 (7.93) Min
.040 (1.02)
V_OUT
.215 (5.45)
.430
(10.92)
1.187 (30.16)
.665
(16.9)
.156 (3.96) Dia
(2 Holes)
.188 (4.8) R Max
GND
.525 (13.35) R Max
V_IN/Case