NTE1913 Datasheet, PDF (2/2 Pages) NTE Electronics – Integrated Circuit Negative 3 Terminal Voltage Regulator, -5V, 1.5A

Electrical Characteristics: (0° ≤ T_J ≤ +125°C, P_D ≤ 1.5W, V_O = –5V, V_IN = –10V, I_O = 500mA,
C_IN = 2.2µF, C_OUT = 1µF unless otherwise specified)
Parameter
Symbol
Test Conditions
Min Typ Max Unit
Output Voltage
V_O T_J = +25°C
–4.8 –5.0 –5.2 V
–20V ≤ V_IN ≤ –7.5V, 5mA ≤ I_O ≤ 1A, P ≤ 15W –7.45 –5.00 –5.25 V
Line Regulation
Reg_Line T_J = +25°C, –25V ≤ V_IN ≤ –7V, Note 2
–
8
50 mV
Load Regulation
T_J = +25°C, –12V ≤ V_IN ≤ –8V, Note 2
Reg_Load T_J = +25°C, 5mA ≤ I_O ≤ 1.5A, Note 2
–
2
15 mV
–
15 100 mV
T_J = +25°C, 250mA ≤ I_O ≤ 750A, Note 2
–
5
50 mV
Quiescent Current
I_Q T_J = +25°C
–
1
2
mA
Quiescent Current Line
Quiescent Current Load
Output Noise Voltage
I_Q(Line)
I_Q(Load)
V_N
–25V ≤ V_IN ≤ –7V
5mA ≤ I_O ≤ 1.5A
T_A = +25°C, f = 10Hz to 100Hz
–
– 0.5 mA
–
– 0.5 mA
– 125 –
µV
Ripple Rejection
RR –18V ≤ V_IN ≤ –8V, f = 120Hz
54 66
–
dB
Dropout Voltage
peak Output Current
Temperature Coefficient
I_Omax
T_J = +25°C, I_O = 1A
T_J = +25°C
0° ≤ T_J ≤ +100°C, I_O = 5mA
–
1.1
–
V
–
2.2
–
A
–
0.4
– mV/°C
Note 2. Regulation is measured at a constant temperature by pulse testing with a low duty cycle.
Change in output voltage due to heating effects must be taken into account.
.135 (3.45) Max
.350 (8.89)
.875 (22.2)
Dia Max
Seating
Plane
.312 (7.93) Min
.040 (1.02)
V_OUT
.215 (5.45)
.430
(10.92)
1.187 (30.16)
.665
(16.9)
.156 (3.96) Dia
(2 Holes)
.188 (4.8) R Max
GND
.525 (13.35) R Max
V_IN/Case