SIT1000M50 Datasheet, PDF (1/2 Pages) NTE Electronics – 105 SNAP-IN ALUMINUM ELECTROLYTIC

105°C SNAP–IN ALUMINUM ELECTROLYTIC
SIT SERIES
SUBMINIATURE
(SIT: High Temperature Snap–in)
The SIT Snap–in series subminiature aluminum electrolytic ca-
pacitors are especially suitable for applications requiring high ca-
pacitance, low cost, and very small size. In fact, you’ll find these
capacitors in some of the most demanding applications, from
precision medical electronics and automobiles to the newest
personal computers and disk drives.
They operate over a broad temperature range and are available
in either blister pack or bulk.
RATINGS
Capacitance Range: 100µf to 10,000µf
Tolerance: ±20%
Voltage Range: 50V to 250V
PERFORMANCE SPECIFICATIONS
MECHANICAL SPECIFICATIONS
Marking:
Consists of series type, nominal capacitance, rated
voltage, temperature range, anode and/or cathode
identification, vendor identification.
Recommended Cleaning Solvents:
Chlorofluorocarbon solvents used to remove flux from
printed circuit boards can penetrate the capacitor end–
seals, cause corrosion when voltage is applied and ca-
pacitor failure. Avoid halogenated solvents and consid-
er these alternatives: Clean the capacitors with
water/detergent or cleaning solvents free of halogen
groups such as alcohol or terpene solution, or mount
the capacitor after board cleaning.
CASE SIZE AND DIMENSIONS:
Operating Temperature Range:
–40°C to +105°C (–40°F to +221°F)
Leakage Current: I ≤ 3 x √CV (measured after
5 minutes @ rated voltage and +20°C (+68°F)
I = Leakage Current (µA)
C = Nominal Capacitance (µf)
V = Rated Voltage (V)
Capacitance Tolerance (M): ±20%
measured at +20°C (+68°F), 120H_Z
Surge Voltage:
DC Rated Voltage
50
200
250
Surge Voltage
63
250
300
Load Life: 2000 ±12Hrs @ Max rated temperature
and rated voltage
Leakage Current: Within values specified above
Dissipation Factor: Within ±150% of specified value
SIT SERIES
10.0
Polarity Bar
Vinyl Sleeve
Safety Vent
L+2
Max
2 ±0.1
Dia
10 ±0.1
6.3 ±1
0.8
+0.2
–0.1
DØ+1
Max
2.0 Max
1.5 ±0.2
6.3 ±1
4.0
DØ
PC Board Mounting Holes
Terminal
Shelf Life: 1000 ±6Hrs @ Max rated temperature,
ORDERING INFORMATION
no voltage applied
Leakage Current: Within ±200% of specified value
SIT 1000 M
50
Dissipation Factor: Within ±150% of specified value
Series
Capacitance Change Max: Within ±20% of initial value
Capacitance
Tolerance
Voltage
14
NTE Electronics, Inc. D Voice (800) 631–1250 (973) 748–5089 D FAX (973) 748–6224 D http://www.nteinc.com