NTE5611 Datasheet, PDF (1/2 Pages) NTE Electronics – TRIAC - 10 Amp

NTE5611 thru NTE5618
TRIAC – 10 Amp
Description:
The NTE5611 through NTE5618 TRIACs are designed primarily for full–wave AC control applica-
tions, such as light dimmers, motor controls, heating controls, and power supplies; or wherever full–
wave silicon gate controlled solid–state devices are needed. TRIAC type thyristors switch from a
blocking to a conducting state for either polarity of applied anode voltage with positive or negative gate
triggering.
Features:
D All Diffused and Passivated Junctions for Greater Parameter Uniformity and Stability
D Small, Rugged, Thermopad Construction for Low Thermal Resistance, High Heat Dissipation
and Durability.
D Gate Triggering Guaranteed in Four Modes
Absolute Maximum Ratings: (Note 1)
Repetitive Peak Off–State Voltage (T_J = +100°C, Note 2), V_DRM
NTE5611 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25V
NTE5612 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50V
NTE5613 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100V
NTE5615 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 300V
NTE5618 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 600V
On–State Current RMS (T_C = +75°C), I_T(RMS) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A
Peak Surge Current (One Full Cycle, 60Hz, T_J = –40° to +100°C), I_TSM . . . . . . . . . . . . . . . . . . 100A
Circuit Fusing Considerations (T_J = –40° to +100°C, t = 1.0 to 8.3ms), I²t . . . . . . . . . . . . . . . . 40A²s
Peak Gate Power, P_GM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10W
Average Gate Power, P_G(AV) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5W
Peak Gate Current, I_GM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2A
Operating Junction Temperature Range, T_J . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –40° to +100°C
Storage Temperature Range, T_stg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –40° to +150°C
Mounting Torque (6–32 Screw, Note 3) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12in. lb.
Thermal Resistance, Junction–to–Case, R_thJC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2°C/W
Thermal Resistance, Case–to–Ambient, R_thJA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50°C/W
Note 1. NTE5618 is a discontinued device and no longer available.
Note 2. Ratings apply for open gate conditions. Thyristor devices shall not be tested with a constant
current source for blocking capability such that the voltage applied exceeds the rated block-
ing voltage.
Note 3. Torque rating applies with use of torque washer. Mounting torque in excess of 8 in. lbs. does
not appreciably lower case–to–sink thermal resistance. Anode lead and heatsink contact
pad are common.
Note 4. For soldering purposes (either terminal connection or device mounting), soldering tempera-
tures shall not exceed +230°C.