HD1.0M25 Datasheet, PDF (1/1 Pages) NTE Electronics – HIGH-FREQ ALUMINUM ELECTROLYTIC

HIGH–FREQ ALUMINUM ELECTROLYTIC
HD SERIES
SUBMINIATURE
(Radial Lead, Horizontal Deflection)
The NTE HD series of aluminum electrolytic non–polarized
capacitors are designed specifically for horizontal deflec-
tion current correction where high frequency and high ripple
current occur.
MECHANICAL SPECIFICATIONS
Lead Solderability:
Meets the requirements of MIL–STD 202,
Method 208
Marking:
RATINGS
Capacitance Range: 1.0µf to 10µf
Tolerance: ±20%
Voltage Range: 25 Volts and 50 Volts
PERFORMANCE SPECIFICATIONS
Operating Temperature Range:
Consists of series type, nominal capacitance,
rated voltage, temperature range, anode and/or
cathode identification, NTE identification.
Recommended Cleaning Solvents:
Methanol, isopropanol ethanol, isobutanol, petro-
leum ether, propanol and/or commercial deter-
gents. Halogenated hydrocarbon cleaning
agents such as Freon (MF, TF, or TC), trichloroe-
thylene, trichloroethane, or methylchloride are
not recommended as they may damage the ca-
pacitor.
–25°C to +85°C (–13°F to +185°F)
Leakage Current: I ≤ 0.2CV (measured after
5 minutes of applied rated voltage)
I = Leakage Current (µA)
C = Nominal Capacitance (µf)
V = Rated Voltage (V)
CASE SIZE AND DIMENSIONS:
Insulating
Sleeve
15.0 Min
dØ
A ±0.5
Capacitance Tolerance: ±20% (M)
measured at +20°C (+68°F), 1kH_Z
Load Life: 1000 Hrs @ 12V DC, +70°C (+158°F),
at specified ripple current
Leakage Current: Initial specified value or less
Dissipation Factor: < 200% of specified value
Capacitance Change: Within ±15% of initial value
Shelf Life: 500 Hrs @ +85°C (+185°F),
no voltage applied
Leakage Current: Initial specified value or less
Dissipation Factor: < 200% of specified value
Capacitance Change: Within ±15% of initial value
ORDERING INFORMATION
HD 4.7 M
50
Series
Capacitance
Tolerance
Voltage
L’
5.0 Min
D’ Ø
HD Series Dimensions:
Diameter (D Ø) x Length (L): mm
Capacitance
(µf)
1.0
25V and 50V
12.5 x 20
Ripple Current*
(A_p–p)
2.0
2.2
12.5 x 25
3.0
3.3
16 x 25
4.0
4.7
16 x 31.5
5.0
5.6
16 x 31.5
6.0
6.8
16 x 35.5
7.0
8.2
18 x 35.5
8.0
10.0
18 x 40
9.0
* Allowable ripple current @ 70°C, 12V DC, and 15.75kH_Z
HD Mechanical Specs: Dimensions (mm)
Outside Diameter (D Ø)
Lead Spacing (A)
Lead Wire (d Ø)
12.5 16 18
5.0 7.5 7.5
0.6 0.8 0.8
NTE Electronics, Inc. D Voice (800) 631–1250 (973) 748–5089 D FAX (973) 748–6224 D http://www.nteinc.com
9