LMH0056_07 Datasheet, PDF(8/16 Page) National Semiconductor (TI) – HD/SD SDI Reclocker with 4:1 Input Multiplexer

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

LMH0056_07 Datasheet, PDF (8/16 Pages) National Semiconductor (TI) – HD/SD SDI Reclocker with 4:1 Input Multiplexer

◁

Note 1: âAbsolute Maximum Ratingsâ are those parameter values beyond which the life and operation of the device cannot be guaranteed. The stating herein of

these maximums shall not be construed to imply that the device can or should be operated at or beyond these values. The table of âElectrical Characteristicsâ

specifies acceptable device operating conditions.

Note 2: Current flow into device pins is defined as positive. Current flow out of device pins is defined as negative. All voltages are referenced to VEE (equal to

zero volts).

Note 3: Typical values are stated for: VCC = +3.3V, TA = +25Â°C.

Note 4: Spec is guaranteed by design.

Note 5: RL = 100â¦ differential.

Note 6: Measured from first SDI transition until Lock Detect (LD) output goes high (true).

Note 7: Peak-to-peak amplitude with sinusoidal modulation per SMPTE RP 184-1996 paragraph 4.1. The test data signal shall be color bars.

Note 8: This parameter is guaranteed by characterization over voltage and temperature limits.

Note 9: Refer to âA1â in Figure 1 of SMPTE RP 184-1996.

Note 10: Refer to âA2â in Figure 1 of SMPTE RP 184-1996.

Note 11: Serial Data Output Jitter is total output jitter with 0.2UIP-P input jitter.

Note 12: Characterized to the limitations of SDI test equipment.

www.national.com

▷