|
LMH6551Q-Q1 Datasheet, PDF (6/25 Pages) National Semiconductor (TI) – LMH6551Q Differential, High Speed Op Amp | |||
|
◁ |
LMH6551Q
SNOSB95E â NOVEMBER 2011 â REVISED MARCH 2013
www.ti.com
3.3V Electrical Characteristics (1)
Single ended in differential out, TA= 25°C, G = +1, VS = 3.3V, VCM = 1.65V, RF = RG = 365â¦, RL = 500â¦; Unless specified
Boldface limits apply at the temperature extremes.
Symbol
Parameter
Conditions
Min (2)
Typ (3)
Max (2)
Units
SSBW
LSBW
Small Signal â3 dB Bandwidth
Large Signal â3 dB Bandwidth
Slew Rate
RL = 500â¦, VOUT = 0.5 VPP
RL = 500â¦, VOUT = 1 VPP
1V Step(4)
320
MHz
300
MHz
700
V/μs
Rise/Fall Time, 10% to 90%
1V Step
2
ns
VCM Pin AC Performance (Common Mode Feedback Amplifier)
Common Mode Small Signal
Bandwidth
95
MHz
Distortion and Noise Response
HD2
2nd Harmonic Distortion
HD2
HD3
3rd Harmonic Distortion
HD3
VO = 1 VPP, f = 5 MHz, RL=800â¦
VO = 1 VPP, f = 20 MHz, RL=800â¦
VO = 1VPP, f = 5 MHz, RL=800â¦
VO = 1VPP, f = 20 MHz, RL=800â¦
â93
dBc
â74
dBc
â85
dBc
â69
dBc
(1) Electrical Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very
limited self-heating of the device such that TJ = TA. No specification of parametric performance is indicated in the electrical tables under
conditions of internal self-heating where TJ > TA.
(2) Limits are 100% production tested at 25°C. Limits over the operating temperature range are ensured through correlation using Statistical
Quality Control (SQC) methods.
(3) Typical numbers are the most likely parametric norm.
(4) Slew Rate is the average of the rising and falling edges.
6
Submit Documentation Feedback
Product Folder Links: LMH6551Q
Copyright © 2011â2013, Texas Instruments Incorporated
|
▷ |