LMH6503 Datasheet, PDF (4/20 Pages) National Semiconductor (TI) – Wideband, Low Power, Linear Variable Gain Amplifier

Electrical Characteristics(Note 2) (Continued)
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
intended to be functional, but specific performance is not guaranteed. For guaranteed specifications, see the Electrical Characteristics tables.
Note 2: Electrical Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very limited self-heating of
the device such that T_J = T_A. No guarantee of parametric performance is indicated in the electrical tables under conditions of internal self-heating where T_J > T_A.
Note 3: The maximum output current (I_OUT) is determined by device power dissipation limitations or value specified, whichever is lower.
Note 4: Human body model: 1.5kΩ in series with 100pF. Machine model: 0Ω in series with 200pF.
Note 5: Slew Rate is the average of the rising and falling rates.
Note 6: Typical values represent the most likely parametric norm. Bold numbers refer to over temperature limits.
Note 7: Positive current correspondes to current flowing in the device.
Note 8: Drift determined by dividing the change in parameter distribution at temperature extremes by the total temperature change.
Note 9: CMRR definition: [|∆V_OUT/∆V_CM|/A_V] with 0.1V differential input voltage. ∆V_OUT is the change in output voltage with offset shift subtracted out.
Note 10: +PSRR definition: [|∆V_OUT/∆V⁺| /A_V], -PSRR definition: [|∆V_OUT/∆V^−| /A_V] with 0.1V differential input voltage. ∆V_OUT is the change in output voltage with
offset shift subtracted out.
Note 11: Gain Control Frequency Response Schematic:
20073932
Note 12: Gain/Phase normalized to low frequency value at each A_V.
Note 13: Flat Band Attenuation (Relative To Max Gain) Range Definition: Specified as the attenuation range from maximum which allows gain flatness specified
(either ±0.2dB or ±0.1dB), relative to A_VMAX gain. For example, for f<30MHz, here are the Flat Band Attenuation ranges:
±0.2dB:
10V/V down to 1V/V=20dB range
±0.1dB:
10V/V down to 4.7V/V=6.5dB range
Connection Diagram
14-Pin SOIC/TSSOP
Ordering Information
Package
14-pin SOIC
14-Pin TSSOP
Part Number
LMH6503MA
LMH6503MAX
LMH6503MT
LMH6503MTX
Top View
20073946
Package Marking
LMH6503MA
LMH6503MT
Transport Media
55 Units/Rail
2.5k Units Tape and Reel
94 Units/Rail
2.5k Units Tape and Reel
NSC Drawing
M14A
MTC14
www.national.com
4