CD4016BM Datasheet, PDF (4/8 Pages) National Semiconductor (TI) – Quad Bilateral Switch

AC Electrical Characteristics (Continued)
T_Ae25 C t_ret_fe20 ns and V_SSe0V unless otherwise specified
Symbol
Parameter
Conditions
Min Typ Max Units
Frequency Response Switch
‘‘ON’’ (Frequency at b3 dB)
Feedthrough Switch ‘‘OFF’’
(Frequency at b50 dB)
Crosstalk Between Any Two
Switches (Frequency at b50 dB)
Crosstalk Control Input to
Signal Output
Maximum Control Input
V_CeV_DDe5V V_SSeb5V
R_Le1 kX V_ISe5 V_P-P
20 Log₁₀ V_OS V_OS (1 kHz) bdB
(Figure 4 )
V_DDe5V V_CeV_SSeb5V
R_Le1 kX V_ISe5 V_P-P
20 Log₁₀ (V_OS V_IS)eb50 dB
(Figure 4 )
V_DDeV_C(A)e5V V_SSeV_C(B)eb5V
R_Le1 kXV_IS(A)e5 V_P-P
20 Log₁₀ (V_OS(B) V_OS(A) )eb50 dB
(Figure 5 )
V_DDe10V R_Le10 kX
R_INe1 kX V_CCe10V Square Wave
C_Le50 pF (Figure 6 )
R_Le 1 kX C_Le50 pF (Figure 7 )
V_OS(f)e V_OS(1 kHz)
V_DDe5V
V_DDe10V
V_DDe15V
40
1 25
09
150
65
80
90
MHz
MHz
MHz
mV_P-P
MHz
MHz
MHz
C_IS
Signal Input Capacitance
4
pF
C_OS
Signal Output Capacitance
V_DDe10V
4
pF
C_IOS
Feedthrough Capacitance
V_Ce0V
02
pF
C_IN
Control Input Capacitance
5
75
pF
AC Paramters are guaranteed by DC correlated testing
Note 1 ‘‘Absolute Maximum Ratings’’ are those values beyond which the safety of the device cannot be guaranteed They are not meant to imply that the devices
should be operated at these limits The tables of ‘‘Recommended Operating Conditions’’ and ‘‘Electrical Characteristics’’ provide conditions for actual device
operation
Note 2 V_SSe0V unless otherwise specified
Note 3 These devices should not be connected to circuits with the power ‘‘ON’’
Note 4 In all cases there is approximately 5 pF of probe and jig capacitance on the output however this capacitance is included in C_L wherever it is specified
Note 5 V_IS is the voltage at the in out pin and V_OS is the voltage at the out in pin V_C is the voltage at the control input
Note 6 If the switch input is held at V_DD V_IHC is the control input level that will cause the switch output to meet the standard ‘‘B’’ series V_OH and I_OH output levels
l l ^{If the analog switch input is connected to V}SS ^VIHC ^{is the control input level which allows the switch to sink standard ‘‘B’’ series I}OH ^{high level current and still}
maintain a V_OL s ‘‘B’’ series These currents are shown in Figure 8
AC Test Circuits and Switching Time Waveforms
Figure 1 t_PLH t_PLH Propagation Delay Time Signal Input to Signal Output
FIGURE 2 t_PZH t_PHZ Propagation Delay Time Control to Signal Output
4
TL F 5661 – 2