DP83848J_07 Datasheet, PDF (35/78 Pages) National Semiconductor (TI) – PHYTER® Mini LS Commercial Temperature Single Port 10/100 Ethernet Transceiver

5.4 POWER FEEDBACK CIRCUIT
5.6 ENERGY DETECT MODE
To ensure correct operation for the DP83848J, parallel
caps with values of 10 µF (Tantalum) and 0.1 µF should be
placed close to pin 19 (PFBOUT) of the device.
Pin 16 (PFBIN1) and pin 30 (PFBIN2) must be connected
to pin 19 (PFBOUT), each pin requires a small capacitor
(0.1 µF). See Figure 13 below for proper connections.
Pin 19 (PFBOUT)
When Energy Detect is enabled and there is no activity on
the cable, the DP83848J will remain in a low power mode
while monitoring the transmission line. Activity on the line
will cause the DP83848J to go through a normal power up
sequence. Regardless of cable activity, the DP83848J will
occasionally wake up the transmitter to put ED pulses on
the line, but will otherwise draw as little power as possible.
Energy detect functionality is controlled via register Energy
Detect Control (EDCR), address 0x1Dh.
Pin 16 (PFBIN1)
Pin 30 (PFBIN2)
10 µF ₊
-
0.1 µF
0.1 µF
0.1µF
6.0 Reset Operation
The DP83848J includes an internal power-on reset (POR)
function and does not need to be explicitly reset for normal
operation after power up. If required during normal opera-
tion, the device can be reset by a hardware or software
reset.
Figure 13. Power Feedback Connection
6.1 HARDWARE RESET
A hardware reset is accomplished by applying a low pulse
(TTL level), with a duration of at least 1 µs, to the
RESET_N. This will reset the device such that all registers
will be reinitialized to default values and the hardware con-
figuration values will be re-latched into the device (similar
to the power-up/reset operation).
5.5 POWER DOWN
The device can be put in a Power Down mode by setting bit
11 (Power Down) in the Basic Mode Control Register,
BMCR (0x00h).
6.2 SOFTWARE RESET
A software reset is accomplished by setting the reset bit
(bit 15) of the Basic Mode Control Register (BMCR). The
period from the point in time when the reset bit is set to the
point in time when software reset has concluded is approx-
imately 1 µs.
The software reset will reset the device such that all regis-
ters will be reset to default values and the hardware config-
35
www.national.com