 English |
|
|
|
|
|
|
|
| SERDES24-35OVT_14 Datasheet, PDF (3/5 Pages) National Semiconductor (TI) – Evaluation Kit for OV7710 Image Sensor Application with a FPD-Link II | |||
| |||
| ◁ |
2. Connect the DS90C124 Deserializer board to the OmniVision USB Board.
Refer to Figure 1.
3. Connect the DS90C241 Serializer board to the DS90C124 Deserializer
board via the CAT5 cable.
4. Connect 5V power to the Deserializer board
5. Push âONâ button (S2) on Deserializer board. Green light should now be
visible on RJ45 connectors at Serializer (J3) board and Deserializer (J6)
board.
6. Connect PC/Controller to the Deserializer board via USB cable. Green
light should be visible on USB controller board (D2).
7. Launch Omnivision software (or alternate control application)
Troubleshooting:
Problemâ¦
No image
No green light on RJ45 connectors
No green light on USB board
All lights on, but no image
No image
Solutionâ¦
Check that all RJ45 and USB green
lights are on
Check that 5V power supply is
provided, and CAT cable connection
is good
Cycle âONâ button on deserializer
board
Check that USB is connected to PC
Check that orientation of board
connections is correct
Check that lens cap is removed from
camera
SERDES24-35OVT
Rev 0.2
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese