OPA2652 Datasheet, PDF (3/23 Pages) Burr-Brown (TI) – Dual, 700MHz, Voltage-Feedback OPERATIONAL AMPLIFIER

OPA2652
www.ti.com
SBOS125A – JUNE 2000 – REVISED MAY 2006
ELECTRICAL CHARACTERISTICS: V_S = ±5V
At T_A = +25°C, G = +2, R_F = 402Ω, and R_L = 100Ω, unless otherwise noted. See Figure 28 and Figure 29 for AC
performance only.
PARAMETER
AC PERFORMANCE
Small-Signal Bandwidth
Gain Bandwidth Product
Bandwidth for 0.1dB Flatness
Peaking at a Gain of +1
Slew Rate
Rise-and-Fall Time
Large-Signal Bandwidth
SFDR
Input Voltage Noise
Input Current Noise
Differential Gain Error
Differential Phase Error
Channel-to-Channel Crosstalk
DC PERFORMANCE⁽⁴⁾
Open-Loop Voltage Gain (A_OL)
Input Offset Voltage
Average Offset Drift
Input Bias Current
Input Bias Current Drift
Input Offset Current
Input Offset Current Drift
INPUT ⁽⁴⁾
Common-Mode Input Range
Common-Mode Rejection Ratio
Input Impedance
Differential
Common-Mode
CONDITIONS
(Figure 28 and Figure 29)
G = +1, R_F = 25Ω, V_O = 200mV_PP
G = +2,V_O = 200mV_PP
G = +5,V_O = 200mV_PP
G ≥ +10
V_O = 200mV_PP
G = +1, R_F = 25Ω, V_O = 200mV_PP
4V step
200mV step
4V step
V_O = 4V_PP
V_O = 2V_PP, 5MHz
f > 1MHz
f > 1MHz
NTSC, R_L = 150Ω
NTSC, R_L = 150Ω
f = 5MHz
V_CM = 0V
TYP
+25°C
OPA2652U, E
MIN/MAX OVER
TEMPERATURE
0°C to –40°C to
+25°C⁽²⁾ 70°C⁽³⁾ +85°C⁽³⁾
UNITS
700
200
45
200
50
0
335
2.0
10
50
66
8
1.4
0.05
0.03
–100
MHz
MHz
MHz
MHz
MHz
dB
V/µs
ns
ns
MHz
dB
nV/√Hz
pA/√Hz
%
degrees
dBc
63
56
55
54
dB
±1.5
±7
mV
5
7
µV/°C
4
15
20
25
µA
µA/°C
±0.3
±1.0
±1.4
±2.0
µA
µA/°C
MIN/ TEST
MAX LEVEL⁽¹⁾
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
typ
C
min
A
max
A
max
B
max
A
max
B
max
A
max
B
V_CM = 0V
±4.0
±3.0
±2.8
±2.7
V
min
A
95
75
dB
min
A
35 || 1
18 || 1
kΩ || pF typ
C
MΩ || pF typ
C
(1) Test levels: (A) 100% tested at +25°C. Over temperature limits set by characterization and simulation. (B) Limits set by characterization
and simulation. (C) Typical value only for information.
(2) Junction temperature = ambient for +25°C tested specifications.
(3) Junction temperature = ambient at low temperature limit; junction temperature = ambient +23°C at high temperature limit for over
temperature specifications.
(4) Current is considered positive-out-of node. V_CM is the input common-mode voltage.
Submit Documentation Feedback
3