LMH6702 Datasheet, PDF (3/13 Pages) National Semiconductor (TI) – Ultra Low Distortion, Wideband Op Amp

Electrical Characteristics (Note 2) (Continued)
A_V = +2, V_S = ±5V, R_L = 100Ω, R_F = 237Ω; unless specified
Symbol
Parameter
Conditions
Static, DC Performance
V_IO
Input Offset Voltage
DV_IO
I_BN
Input Offset Voltage Average
Drift
Input Bias Current
(Note 8)
Non-Inverting (Note 7)
DI_BN
I_BI
Input Bias Current Average Drift Non-Inverting (Note 8)
Input Bias Current
Inverting (Note 7)
DI_BI
PSRR
Input Bias Current Average Drift Inverting (Note 8)
Power Supply Rejection Ratio DC
CMRR Common Mode Rejection Ration DC
I_CC
Supply Current
Miscellaneous Performance
R_IN
C_IN
R_OUT
V_OL
Input Resistance
Input Capacitance
Output Resistance
Output Voltage Range
CMIR
I_O
Input Voltage Range
Output Current
R_L = ∞
Non-Inverting
Non-Inverting
Closed Loop
R_L = 100Ω
Common Mode
Min
(Note 6)
47
45
45
44
11.0
10.0
±3.3
±3.2
±1.9
50
Typ
(Note 6)
±1.0
−13
−6
+40
−8
−10
52
48
12.5
1.4
1.6
30
±3.5
±2.2
80
Max
(Note 6)
Units
±4.5
±6.0
mV
µV/˚C
±15
µA
±21
nA/˚C
±30
µA
±34
nA/˚C
dB
dB
16.1
mA
17.5
MΩ
pF
mΩ
V
V
mA
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
intended to be functional, but specific performance is not guaranteed. For guaranteed specifications, see the Electrical Characteristics tables.
Note 2: Electrical Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very limited self-heating of
the device such that T_J = T_A. No guarantee of parametric performance is indicated in the electrical tables under conditions of internal self-heating where T_J > T_A.
Min/Max ratings are based on production testing unless otherwise specified.
Note 3: The maximum output current (I_OUT) is determined by device power dissipation limitations.
Note 4: Human body model: 1.5kΩ in series with 100pF. Machine model: 0Ω in series with 200pF.
Note 5: Slew Rate is the average of the rising and falling edges.
Note 6: Typical numbers are the most likely parametric norm. Bold numbers refer to over temperature limits.
Note 7: Negative input current implies current flowing out of the device.
Note 8: Drift determined by dividing the change in parameter at temperature extremes by the total temperature change.
Note 9: Harmonic distortion is strongly influenced by package type (SOT23-5 or SOIC). See Application Note section under "Harmonic Distortion" for more
information.
3
www.national.com