LMC6008 Datasheet, PDF(3/4 Page) National Semiconductor (TI)

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

LMC6008 Datasheet, PDF (3/4 Pages) National Semiconductor (TI) – 8 Channel Buffer

◁

AC Electrical Characteristics

Unless otherwise specified all limits guaranteed for TJ e 25 C VCC e 14 5V and RL e 0X

Symbol

Parameter

Conditions

Typ

(Note 5)

LMC6008

Limit

(Note 6)

Units

Slew Rate

Buffers 1 3 5 7 (Note 3)

1 70

V ms min

Buffers 2 4 6 8 (Note 3)

0 85

V ms min

tON

tOFF

PBW

Settling Time

Standby Response Time ON

Standby Response Time OFF

Power Bandwidth

(Notes 3 7)

VO e 10 VPP for Hi-Speed

VO e 5 VPP for Lo-Speed

(Note 3)

ms max

KHz min

Load Capacitance

mF max

Note 1 Absolute Maximum Ratings indicate limits beyond which damage to the device may occur Operating ratings indicate conditions for which the device is

intended to be functional but specific performance is not guaranteed For guaranteed specifications and the test conditions see the Electrical Characteristics

Note 2 Human body model 1 5 kX in series with 100 pF

Note 3 The Load is a series connection of a 0 1 mF capacitor and a 1X resistor

Note 4 The maximum power dissipation is a function of TJ(max) iJA and TA The maximum allowable power dissipation at any ambient temperature is

PD e (TJ(max) b TA) iJA where the junction-to-ambient thermal resistance iJA e 50 C W If the maximum allowable power dissipation is exceeded the thermal

limit circuit will limit the die temperature to approximately 160 C All numbers apply for packages soldered directly into a PC board

Note 5 Typical Values represent the most likely parametric norm

Note 6 All limits are guaranteed by testing or statistical analysis

Note 7 The settling time is measured from the input transition to a point 50 mV of the final value for both rising and falling transitions The input swing is 0 5V to

13 5V for buffers 1 3 5 7 and 3 75V to 10 25V for buffers 2 4 6 8 Input rise time should be less than 1 ms

Note 8 High-Speed Buffers are 1 3 5 7 and Low-Speed Buffers are 2 4 6 8

Note 9 Output Voltage Difference is the difference between the highest and lowest buffer output voltage when all buffer inputs are at identical voltages

http www national com

▷