DS55115 Datasheet, PDF (3/6 Pages) National Semiconductor (TI) – Dual Differential Line Receiver

Electrical Characteristics (Notes 2 3 and 5) (Continued)
Symbol
Parameter
Conditions
DS75115
Min
Typ
Max
Units
R_T
Line Terminating
V_CC e 5V
Resistance
T_A e 25 C
74
130
179
X
I_OS
Short-Circuit Output
Current
V_CC e Max V_O e 0V
V_ID e b0 5V (Note 4)
T_A e 25 C
b14
b40
b100
mA
I_CC
Supply Current (Both
V_CC e Max V_ID e 0 5V
T_A e 25 C
Receivers)
V_IC e 0V
32
50
mA
Note 1 ‘‘Absolute Maximum Ratings’’ are those values beyond which the safety of the device cannot be guaranteed Except for ‘‘Operating Temperature Range’’
they are not meant to imply that the devices should be operated at these limits The table of ‘‘Electrical Characteristics’’ provides conditions for the actual device
operation
Note 2 Unless otherwise specified min max limits apply across the b55 C to a125 C temperature range for the DS9615M and across the 0 C to a70 C range for
the DS75115 All typical values are for T_A e 25 C V_CC e 5V and V_CM e 0V
Note 3 All currents into device pins shown as positive out of device pins as negative all voltages referenced to ground unless otherwise noted All values shown
as max or min on absolute value basis
Note 4 Only one output at a time should be shorted
Note 5 Unless otherwise noted V_STROBE e 2 4V All parameters with the exception of off-state open-collector output current are measured with the active pull-up
connected to the sink output
Switching Characteristics V_CC e 5V C_L e 30 pF T_A e 25 C
Symbol
t_PLH
t_PHL
Parameter
Propagation Delay Time Low-
to-High Level Output
Propagation Delay Time High-
to-Low Level Output
Conditions
R_L e 3 9 kX (Figure 1)
R_L e 390X (Figure 1)
DS75115
Min
Typ
Max
18
75
20
75
Units
ns
ns
Schematic Diagram
TL F 5787 – 2
3
http www national com