LMH0001_08 Datasheet, PDF (2/6 Pages) National Semiconductor (TI) – SMPTE 259M / 344M Serial Digital Cable Driver

Absolute Maximum Ratings (Note 1)
Supply Voltage:
Input Voltage (all inputs)
Output Current
Storage Temperature Range
Junction Temperature
Lead Temperature
(Soldering 4 Sec)
Package Thermal Resistance
 θ_JA 16-pin LLP
 θ_JC 16-pin LLP
−0.5V to 3.6V
−0.3V to V_CC+0.3V
28mA
−65°C to +150°C
+150°C
+260°C
+78.9°C/W
+42.7°C/W
ESD Rating (HBM)
ESD Rating (MM)
5kV
250V
Recommended Operating
Conditions
Supply Voltage (V_CC – V_EE):
Operating Free Air Temperature (T_A)
3.3V ±5%
−40°C to +85°C
DC Electrical Characteristics
Over Supply Voltage and Operating Temperature ranges, unless otherwise specified (Notes 2, 3).
Symbol Parameter
V_CMIN Input Common Mode Voltage
Conditions
V_SDI
Input Voltage Swing
V_CMOUT Output Common Mode Voltage
Differential
V_SDO
Output Voltage Swing
I_CC
Supply Current
Single-ended, 75Ω load,
R_REF = 750Ω 1%
Single-ended, 75Ω load,
R_REF = 590Ω 1%
(Note 5)
Reference
SDI, SDI
SDO, SDO
Min
1.6 +
V_SDI/2
100
750
Typ
V_CC –
V_SDO
800
Max
V_CC –
V_SDI/2
2000
850
Units
V
mV_P−P
V
mV_P-P
900
1000
1100 mV_P-P
38
43
mA
AC Electrical Characteristics
Over Supply Voltage and Operating Temperature ranges, unless otherwise specified (Note 3).
Symbol Parameter
Conditions
Reference
Min
Typ
Max Units
DR_SDI
t_jit
t_r,t_f
Input Data Rate
Additive Jitter
Output Rise Time, Fall Time
Mismatch in Rise/Fall Time
(Note 4)
270 Mbps
20% – 80%
(Note 4)
SDI, SDI
540 Mbps
SDO, SDO
18
ps_P-P
400
560
800
ps
30
ps
Duty Cycle Distortion
(Note 4)
100
ps
t_OS
RL_SDO
Output Overshoot
Output Return Loss
(Note 4)
(Note 6)
8
%
15
20
dB
Note 1: "Absolute Maximum Ratings" are those parameter values beyond which the life and operation of the device cannot be guaranteed. The stating herein of
these maximums shall not be construed to imply that the device can or should be operated at or beyond these values. The table of "Electrical Characteristics"
specifies acceptable device operating conditions.
Note 2: Current flow into device pins is defined as positive. Current flow out of device pins is defined as negative. All voltages are stated referenced to V_EE = 0
Volts.
Note 3: Typical values are stated for V_CC = +3.3V and T_A = +25°C.
Note 4: Specification is guaranteed by characterization.
Note 5: Maximum I_CC is measured at V_CC = +3.465V and T_A = +70°C.
Note 6: Output return loss is dependent on board design. The LMH0001 meets this specification on the SD001SQ evaluation board from 5MHz to 1.5GHz.
www.national.com
2