LP3874-ADJ Datasheet, PDF (1/15 Pages) National Semiconductor (TI) – 0.8A Fast Ultra Low Dropout Linear Regulators

October 2006
LP3874-ADJ
0.8A Fast Ultra Low Dropout Linear Regulators
General Description
The LP3874-ADJ fast ultra low-dropout linear regulators op-
erate from a +2.5V to +7.0V input supply. These ultra low
dropout linear regulators respond very quickly to step
changes in load, which makes them suitable for low voltage
microprocessor applications. The LP3874-ADJ is developed
on a CMOS process which allows low quiescent current
operation independent of output load current. This CMOS
process also allows the LP3874-ADJ to operate under ex-
tremely low dropout conditions.
Dropout Voltage: Ultra low dropout voltage; typically 24mV
at 80mA load current and 240mV at 0.8A load current.
Ground Pin Current: Typically 6mA at 0.8A load current.
Shutdown Mode: Typically 10nA quiescent current when
the shutdown pin is pulled low.
Adjustable Output Voltage: The output voltage may be
programmed via two external resistors.
Features
n Ultra low dropout voltage
n Low ground pin current
n Load regulation of 0.04%
n 10nA quiescent current in shutdown mode
n Guaranteed output current of 0.8A DC
n Available in TO-263, TO-220 and SOT-223 packages
n Minimum output capacitor requirements
n Overtemperature/overcurrent protection
n −40˚C to +125˚C junction temperature range
Applications
n Microprocessor power supplies
n GTL, GTL+, BTL, and SSTL bus terminators
n Power supplies for DSPs
n SCSI terminator
n Post regulators
n High efficiency linear regulators
n Battery chargers
n Other battery powered applications
Typical Application Circuit
*See Application Hints
© 2006 National Semiconductor Corporation DS200745
20074545
www.national.com