DS3658 Datasheet, PDF (1/4 Pages) National Semiconductor (TI) – Quad High Current Peripheral Driver

March 1995
DS3658 Quad High Current Peripheral Driver
General Description
The DS3658 quad peripheral driver is designed for those
applications where low operating power high breakdown
voltage high output current and low output ON voltage are
required A unique input circuit combines TTL compatibility
with high impedance In fact its extreme low input current
allows it to be driven directly by a CMOS device
The outputs are capable of sinking 600 mA each and offer a
70V breakdown However for inductive loads the output
should be clamped to 35V or less to avoid latch-up during
turn off (inductive fly back protection refer AN-213) An on-
chip clamp diode capable of handling 800 mA is provided at
each output for this purpose In addition the DS3658 incor-
porates circuitry that guarantees glitch-free power up or
down operation and a fail-safe feature which puts the output
in a high impedance state when the input is open
The molded package is specifically constructed to allow in-
creased power dissipation over conventional packages The
four ground pins are directly connected to the device chip
with a special copper lead frame When the quad driver is
soldered into a PC board the power rating of the device
improves significantly
Applications
Y _{Relay drivers}
Y _{Lamp drivers}
Y _{Solenoid drivers}
Y _{Hammer drivers}
Y _{Stepping motor drivers}
Y _{Triac drivers}
Y _{LED drivers}
Y _{High current high voltage drivers}
Y _{Level translators}
Y _{Fiber optic LED drivers}
Features
Y _{Single saturated transistor outputs}
Y _{Low standby power 10 mW typical}
Y _{High impedance TTL compatible inputs}
Y _{Outputs may be tied together for increased current ca-}
pacity
Y _{High output current}
600 mA per output
2 4A per package
Y _{No output latch-up at 35V}
Y _{Low output ON voltage (350 mV typ 600 mA)}
Y _{High breakdown voltage (70V)}
Y _{Open collector outputs}
Y _{Output clamp diodes for inductive fly back protection}
Y _{NPN inputs for minimal input currents (1 mA typical)}
Y _{Low operating power}
Y _{Standard 5V power supply}
Y _{Power up down protection}
Y _{Fail safe operation}
Y _{2W power package}
Y _{Pin-for-pin compatible with SN75437}
Connection Diagram
Dual-In-Line Package
Truth Table
IN
EN
OUT
H
H
L
L
H
Z
H
L
Z
L
L
Z
H e High state
L e Low state
Z e High impedance state
Top View
Order Number DS3658N
See NS Package Number N16E
TL F 5819 – 1
C1995 National Semiconductor Corporation TL F 5819
RRD-B30M105 Printed in U S A