100352 Datasheet, PDF (1/8 Pages) National Semiconductor (TI) – Low Power 8-Bit Buffer with Cut-Off Drivers

August 1998
100352
Low Power 8-Bit Buffer with Cut-Off Drivers
General Description
The 100352 contains an 8-bit buffer, individual inputs (Dn),
outputs (Qn), and a data output enable pin (OEN). A Q out-
put follows its D input when the OEN pin is LOW. A HIGH on
OEN holds the outputs in a cut-off state. The cut-off state is
designed to be more negative than a normal ECL LOW level.
This allows the output emitter-followers to turn off when the
termination supply is −2.0V, presenting a high impedance to
the data bus. This high impedance reduces termination
power and prevents loss of low state noise margin when sev-
eral loads share the bus.
The 100352 outputs are designed to drive a doubly termi-
nated 50Ω transmission line (25Ω load impedance). All in-
puts have 50 kΩ pull-down resistors.
Features
n Cut-off drivers
n Drives 25Ω load
n Low power operation
n 2000V ESD protection
n Voltage compensated operating range = −4.2V to −5.7V
n Available to industrial grade temperature range
n Available to MIL-STD-883
Logic Symbol
Pin Names
D₀– D₇
OEN
Q₀– Q₇
NC
DS100296-1
Description
Data Inputs
Output Enable Input
Data Outputs
No Connect
© 1998 National Semiconductor Corporation DS100296
www.national.com