CF5011 Datasheet, PDF (4/7 Pages) Nippon Precision Circuits Inc – 1.8V Crystal Oscillator Module ICs

CF5011 series
Switching Characteristics
V_DD = 1.6 to 2.0V, V_SS = 0V, Ta = −20 to +80°C unless otherwise noted.
Parameter
Symbol
Condition
Rating
Unit
min typ max
Output rise time
t_r
Measurement cct 3, load cct 1, 0.2V_DD to 0.8V_DD , C_L = 15pF
–
Output fall time
t_f
Measurement cct 3, load cct 1, 0.8V_DD to 0.2V_DD , C_L = 15pF
–
Output duty cycle¹
Duty
Measurement cct 3, load cct 1, Ta = 25°C, V_DD = 1.8V, C_L = 15pF,
f ≤ 70MHz
40
Output disable delay time² t_PLZ
–
Output enable delay time²
t_PZL
Measurement cct 3, load cct 1, Ta = 25°C, V_DD = 1.6V, C_L ≤ 15pF
–
1
3.5
ns
1
3.5
ns
–
60
%
–
100
ns
–
100
ns
1. Monitored in sample lots.
2. In the case of the CF5011AL×, oscillator stop function is built-in. When INHN goes LOW, normal output stops. When INHN goes HIGH, normal output
is not resumed until after the oscillator start-up time has elapsed.
Current consumption and Output waveform with NPC’s standard crystal
Cb
L Ca R
f (MHz)
30
40
50
60
70
R (Ω)
18.62
20.53
22.17
15.37
25.42
L (mH)
16.24
11.34
7.40
3.83
4.18
Ca (fF)
1.733
1.396
1.370
1.836
1.254
Cb (pF)
5.337
3.989
4.105
5.191
5.170
FUNCTIONAL DESCRIPTION
Standby Function
Output three-state function (CF5011AL×, CF5011AN×)
When INHN goes LOW, the oscillator output on Q goes high impedance.
Oscillator stop function (CF5011AL×)
When INHN goes LOW, the oscillator stops.
Version
CF5011AL×
CF5011AN×
INHN
HIGH (or open)
LOW
HIGH (or open)
LOW
Q
f_O output frequency
High impedance
f_O output frequency
High impedance
Oscillator
Normal operation
Stop
Normal operation
Normal operation
NIPPON PRECISION CIRCUITS INC.—4