SM8220 Datasheet, PDF (3/8 Pages) Nippon Precision Circuits Inc – Calling Number Identification Receiver IC

PIN DESCRIPTIONS
SM8220/SM8221
Number
SM8220 SM8221
1
1
Name
TIP
2
2
RING
3
-
AGND
4
-
RDIN
5
-
RDRC
6
-
RDET
7
3
PDWN
8
4
GND
9
5
OSCIN
/CLKIN
10
-
OSCOUT
11
6
CDET
12
-
NC
13
7
DOUT
14
-
DMIN
15
-
FOUT
16
8
VDD
i/o
Function
i Tip Input: This pin is connected to the tip side of the twisted pair telephone wires.
This pin must be DC isolated from the phone line.
i Ring Input: This pin is connected to the ring side of the twisted pair telephone wires.
This pin must be DC isolated from the phone line.
o Analog Ground: 1/2 VDD voltage output. This pin must be grounded through 0.1 µF capacitor.
si Ring Detect Input: The attenuated ring signal is connected to this pin for the ring detection.
od Ring Detect RC Terminal: An RC network will be connected to this pin to set time delays for
the ring signal detection.
o Ring Detect Output: This pin is an output of a schmitt trigger buffer which input is connected
to RDRC pin. The low level at this pin indicates that the ring signal is detected.
si Power Down Control: This pin must be kept at low level for the normal operation.
When it is high, the device will be in the power down.
Under the power down mode, OSCOUT, CDET and DOUT pins are set to high level and
AGND, FOUT pins are set to high impedance.
- Device Ground: This pin is connected to the system ground.
i Crystal Oscillator Input: A crystal will be connected between this pin and OSCOUT pin.
This pin may be driven from an external clock source.
o Crystal Oscillator Output: A crystal will be connected between this pin and OSCIN pin.
This pin must be kept open when OSCIN pin is driven from an external clock source.
o Carrier Detect Output: When low, this output indicates that a valid carrier present on the line.
- No connection pin.
o Data Out: This pin presents the output of the demodulator while CDET pin is low.
When CDET pin goes high, this pin is held high.
i Demodulator Input: This pin is connected from FOUT pin through a 0.1µF capacitor.
No other components should be connected to this pin.
o Band Pass Filter Output: This pin is connected to DMIN pin through a 0.1µF capacitor.
No other components should be connected to this pin.
- Power Supply: Positive power supply pin.
(Note) si: Schmitt Triger Input, od: Open Drain Output.
NIPPON PRECISION CIRCUITS-3