|
PSGSERIES Datasheet, PDF (1/2 Pages) Nippon Precision Circuits Inc – CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS | |||
|
CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
New!
Radial Lead
ËSuper low ESR, high ripple current capability
ËEndurance: 2,000 to 5,000 hours at 105Ë
ËRated voltage : 16 to 20Vdc
ËRoHS Compliant
ËHalogen Free
PSG
Downsized
PSF
ËSPECIFICATIONS
Items
Category
Temperature Range
-55 to +105Ë
Characteristics
Rated Voltage
Capacitance Tolerance
Surge Voltage
Leakage Current
*Note
Dissipation Factor
(tanÐ)
Low Temperature
Characteristics
(Max.Impedance Ratio)
Endurance
Bias Humidity Test
Surge Voltage Test
Failure Rate
16 to 20Vdc
P20% (M)
Rated voltage(V)B1.15
I=0.2CV or 500μA, whichever is greater
Where, I : Leakage current (μA), C : Nominal capacitance (μF), V : Rated voltage (V)
(at 20Ë, 120Hz)
(at 105Ë)
(at 20Ë after 2 minutes)
0.12 max.
(at 20Ë, 120Hz)
Z(-25Ë)/Z(+20Ë)ʽ1.15
Z(-55Ë)/Z(+20Ë)ʽ1.25
(at 100kHz)
The following specifications shall be satisfied when the capacitors are restored to 20Ë after the rated voltage is applied for 5,000 hours
(20V : 2,000 hours) at 105Ë.
Appearance
No significant damage
Capacitance change ʽʶ20% of the initial value
D.F. (tanÐ)
ʽThe initial specified value
ESR
ʽ150% of the initial specified value
Leakage current
ʽThe initial specified value
The following specifications shall be satisfied when the capacitors are restored to 20Ë after subjecting them to DC voltage at 60Ë,
90 to 95% RH for 1,000 hours.
Appearance
No significant damage
Capacitance change ʽʶ20% of the initial value
D.F. (tanÐ)
ʽThe initial specified value
ESR
ʽ150% of the initial specified value
Leakage current
ʽThe initial specified value
The capacitors shall be subjected to 1,000 cycles each consisting of charge with the surge voltage specified at 105Ë for 30 seconds
through a protective resistor(R=1kÐ) and discharge for 5 minutes 30 seconds.
Appearance
No significant damage
Capacitance change ʽʶ20% of the initial value
D.F. (tanÐ)
ʽThe initial specified value
ESR
ʽ150% of the initial specified value
Leakage current
ʽThe initial specified value
0.5% per 1,000 hours maximum (Confidence level 60% at 105Ë)
*Note : If any doubt arises, measure the leakage current after the following voltage treatment.
Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105Ë.
Product speciï¬cations in this catalog are subject to change without notice.Request our product speciï¬cations before purchase and/or use. Please use our products based on the information contained in this catalog and product speciï¬cations.
(1/2)
CAT. No. E1001L
|
▷ |