YB215CWCKW01-6B-JB Datasheet, PDF (10/11 Pages) Nihon Kaiheiki Industry Co. Ltd. – Panel Seal Pushbuttons

Panel Seal Pushbuttons
Series YB2
SQUARE ASSEMBLY INSTRUCTIONS
1. Remove knurled
mounting nut.
Spacer
5. Install the blue o-ring which
was removed in step 2 at
the inside bottom of the
bezel.
Blue
O-ring
Bezel
6. Align tab inside of the bezel with keyway on housing and
bring bezel back into its original position.
2. Remove bezel and
blue o-ring from
housing.
Bezel
Blue
O-ring
Housing
Bezel
D
Keyway
Tab
3. Install LED.
Part Number
This Side
Cathode
Socket (–)
LEDs
AT634 & AT636
D-Flat
(+) _(–)
LED AT628
D-Flat
(+)
(–)
LEDs AT625G,
AT631B,
AT632F
Anode
Socket (+)
ATTENTION
E L E C T R O S TAT I C
SENSITIVE DEVICES
Align D-flat on LED with Part Number
on switch for appropriate polarity and
insert LED into base.
Align D-flat on LED with Part Number
on switch for appropriate polarity and
insert LED into base.
ATTENTION
E L E C T R O S TAT I C
SENSITIVE DEVICES
The larger metal part within the LED
represents the cathode (–). Align LED
for appropriate polarity and insert LED
into base.
7. Before installing into
panel, make sure that
the square gasket is
present at the back of
the bezel. Align keyway
on bezel with tab in
panel and push switch
all the way into the
panel.
Back of
Bezel
Bezel
Panel
8. Attach mounting nut behind panel and tighten. Make
sure that bezel and actuator fit properly and that there is
no space between bezel and panel. Do not overtighten.
Mounting torque: 0.785Nm (6.95 lb•in) maximum.
Optional socket wrench AT106 available.
Actuator
Bezel
Panel
(–)
(+)
Cathode (–)
4. Align tabs (B) on both
sides of actuator with
the projections (A) inside
B
of the housing and push
actuator firmly down to
snap in.
Anode (+)
Actuator
A
Housing
Spacer
Knurled Nut
AT106 Socket Wrench
w w w.nkk.com
D123