1N3506A Datasheet, PDF (2/2 Pages) Microsemi Corporation – ZENER VOLTAGE REGULATOR DIODE

400mW ZENER VOLTAGE REGULATOR DIODE
ELECTRICAL CHARACTERISTICS (CONT.) (TA = 2S°C, unless otherwise specified)
Zener Type #
1N3532A
1N3533A
. 1N3534A
Zener Voltage @ Izt
Volts
@mA
39.0
3.0
43.0
2.0
47.0
2,0
Zener Voltage
Tolerance
5%
5%
5%
Max Zener Impedance @ Izt
Ohms
100.0
130,0
150.0
Power Rating
400mW
400mW
400mW
NOTE 1 :Zener Voltage is measured with the device junction in thermal equilibrium at an ambient temperature of 25°C + 3°C.
NOTE 2 : Zener impedance is derived by superimposing on IZT A 60Hz rms a.c. current equal to 10% of IZT-
NOTE 3 : AVZ is the maximum difference between VZ at IZT and VZ at IZT measured with the device junction in thermal
equilibrium.
1
«Jk -jU,
K
-~\
Dimensions
Ltr
Inches
Millimeters
Notes
Min
Max
Min
Max
BD
.056
.107
1.40
2.72
3
BL
.120
.300
3.05
7.62
3
LD
.018
.022
0.46
0.56
LL
1.000
1.500
25.40 38.10
U-1
.050
1.27
4
NOTES:
1. Dimensions are in inches.
2. Millimeter equivalents are given for general Information only.
3. Package contour optional within BD and length BL. Heat slugs, if any. shall be
Included within this cylinder but shall not be subject to minimum limit of BD. The BL
dimension shall include the entire body including slugs.
4. Within this zone lead, diameter may vary to allow for lead finishes and irregularities
other than heat slugs.
5. In accordance with ASME Y14.5M, diameters are equivalent to <|>x syrrtbology.
DESIGN DATA
CASE: DO-35 Hermetically sealed glass case.
LEAD FINISH: Tin/Lead
Cathode band denotes polarity