U401 Datasheet, PDF (1/2 Pages) Calogic, LLC – Dual N-Channel JFET Switch

20 STERN AVE.
SPRINGFIELD, NEW JERSEY 07081
U.S.A.
One,
TELEPHONE: [phone]
[phone]
FAX: [phone]
U401 - U406
FEATURES
• Minimum System Error and Calibration
• Low Drift With Temperature
• Operates From Low Power Supply Voltages
• High Output Impedance
PIN CONFIGURATION
TO-71
ABSOLUTE MAXIMUM RATINGS
(TA = 25°C unless otherwise specified)
Gate-Drain or Gate-Source Voltage
Gate Current (Note 1)
Storage Temperature Range
Operating Temperature Range
Lead Temperature (Soldering, 10sec)
50V
10mA
-65°C to +200°C
-55°C to +150°C
+300°C
Power Dissipation (TA = 85°C)
Derate above 25°C
One Side
300mW
2.6mW/°C
Both Sides
SOOmW
5mW/°C
NOTE: Stresses above those listed under "Absolute Maximum
Ratings" may cause permanent damage to the device. These are
stress ratings only and functional operation of the device at these or
any other conditions above those indicated in the operational sections
of the specifications is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
ORDERING INFORMATION
Part
Package
U401-6 Hermetic TO-71
XU401-6 Sorted Chips in Carriers
Temperature Range
-55°C to+150°C
-55°Cto+150°C
NJ Semi-Conductors reserves the right to change test conditions, parameter limits and package dimensions without
notice. Information furnished by NJ Semi-Conductors is believed to.be both accurate and reliable at the time of going
to press. However, NJ Semi-Conductors assumes no responsibility for any errors or omissionsdiscovered in its use.
NJ Semi-Conductorsencourages customers to verify that datasheets are current before placing orders.
Quality Semi-Conductors