T2322B Datasheet, PDF (1/2 Pages) ON Semiconductor – Sensitive Gate Triacs Silicon Bidirectional Thyristors

Jziizu Jbtmi-donaackoi L/^ioaucts., One,
O'
t/
20 STERN AVE.
SPRINGFIELD, NEW JERSEY 07081
U.S.A.
Sensitive Gate Triac
Silicon Bidirectional Triode Thyristor
TELEPHONE: [phone]
T2322B
. . . designed primarily for ac power switching. The gate sensitivity of these triacs
permits the use of economical transistorized or integrated circuit control circuits, and
it enhances their use in low-power phase control and load-switching applications.
• Very High Gate Sensitivity
• Low On-State Voltage at High Current Levels
• Glass-Passivated Chip for Stability
• Small, Rugged Thermopad Construction for Low Thermal Resistance, High Heat
Dissipation and Durability
SENSITIVE GATE TRIACs
2.5 AMPERES RMS
200 VOLTS
MT2 O-
-O MT1
MT2
MAXIMUM RATINGS (Tj = 25°C unless otherwise noted.;
Rating
Symbol
Value
Unit
Peak Repetitive Off-State VoltageC1) (Tj = 25 to 100°C, Gate Open)
RMS On-State Current (Trj = 70°C)
(Full-Cycle Sine Wave 50 to 60 Hz)
VDRM
200
Volts
'T(RMS)
2.5
Amps
Peak Non-repetitive Surge Current
(One Full Cycle, 60 Hz)
ITSM
25
Amps
Circuit Fusing
(t = 8.3ms)
|2t
2.6
A2S
Peak Gate Power (1 us)
Average Gate Power (TC = 60°C + 38.3 ms)
Peak Gate Current (1 jis)
Operating Junction Temperature Range
PGM
PG(AV)
'GM
Tj
10
0.15
- 0.5
-40 to +110
Watts
Watt
Amp
°C
Storage Temperature Range
Mounting Torque (6-32 Screw)(2)
Tstg
-40to+150
°C
—
8
in. Ib.
1. VrjRM for all types can be applied on a continuous basis. Blocking voltages shall not be tested with a constant current source such that the
voltage ratings of the devices are exceeded.
2. Torque rating applies with use of torque washer (Shakeproof WD19523 or equivalent). Mounting Torque in excess of 6 in. Ib. does not
appreciably lower case-to-sink thermal resistance. Main terminal 2 and heat-sink contact pad are common.
For soldering purposes (either terminal connection or device mounting), soldering temperatures shall not exceed +200°C, for 10 seconds.
Consult factory for lead bending options.
NJ Semi-Conductors reserves the right to change test conditions, parameter limits and package dimensions without
notice. Information furnished by NJ Semi-Conductors is believed to.be both accurate and reliable at the time of going
to press. However, NJ Semi-Conductors assumes no responsibility for any errors or omissionsdiscovered in its use.
NJ Semi-Conductorsencouragescustomers to verify that datasheets are current before placing orders.
Quality Semi-Conductors