S3700B Datasheet, PDF (1/2 Pages) New Jersey Semi-Conductor Products, Inc. – 5-A Silicon Controlled Rectifiers

^zmi-donaiictoi iJ-^ioaucti,, Una,
20 STERN AVE.
SPRINGFIELD, NEW JERSEY 07081
U.S.A.
S3700 Series
5-A Silicon Controlled Rectifiers
For Inverter Applications
Features:
• 600V. 125'C Tj operating
• High dv/dt and dl/dt capability
• Low switching losses
• High pulse-current capability
• Low forward and reverse leakage
• SIPOS oxide glass multilayer passivation system
• Advanced unisurface construction
• Precise Ion-Implanted diffusion source
TELEPHONE: [phone]
[phone]
FAX: [phone]
TERMINAL DESIGNATIONS
•OTTOM VIEW
MDECTO-ttlAA
MAXIMUM RATINGS./»6»Ofufe-MM/mum Values:
Non-repetitive peck raven* voltage:*
Gate Open
Non-repetitive peak off-state voltage:*
GateOpen
Repetitive peak reverse voltage:*
Gate Open
Repetitive peak off-state voltage:*
Gate Open
On-state current:
Tc =B5"Ci conduction angle = 180":
HMS
Average
For other conditions
Peak surge (non-repetitive) on-state current:
For one full cycle of applied principal voltage, Tc = 85'C
60 Hz (sinusoidal)
SO Hz (sinusoidal)
For more than one full cycle of applied principal voltage
Rate of change of on-state current
VD = VDMU. Io7 = 50mA. t, = 0.1/ffl
Fusing current (for SCR protection):
Tj = -40 to 1WC. t = 1 to 8.3 ms
Gate power dissipation:*
Peak Forward (for 100s max.. See Fig. 7)
Peak Reverse (for 10/n max.. See Fig, 8)
Average (averaging time —10 msmax.)
,
Temperature Range:f
Storage
Operating (Case)
Pin Temperature (During soldering):
At distances > 1/32 In. (0.8 mm) from seating plane
for 10 s max
VMW
VMM
VWHM
VDMM
Innnu
|TM«
IT«M
dl/dt
m
POM
PMu
P0«»i
T«
T6
^^
83700B
300
300
200
200
S3700D
500
500
400
400
83700M
700
700
600
600
.3.2 .
i. 3 & 4 .
.80.
.65.
- See Fig. 5 .
.200.
IS
W
IS
Ul
nc
«/
-
- -4fl*0 1ffO
T.
-40 to 175
. . . °C
• These values do not apply If there Is a positive gate signal. Gate must be open or negatively biased.
• Any product of gate current and gate voltage which results in a gate power less then the maximum Is permitted,
t For temperature measurement reference point, aee Dimensions! Outline.
NJ Semi-Conductors reserves the right to change test conditions, parameter limits and package dimensions without
notice. Information furnished by NJ Semi-Conductors is believed to.be both accurate and reliableat the time of going
to press. However, NJ Semi-Conductors assumes no responsibilityfor any errors or omissions discovered in its use.
NJ Semi-Conductors encourages customers to verify that datasheets are current before placing orders.
Quality Semi-Conductors