English
Language : 

N3260-73 Datasheet, PDF (1/1 Pages) New Jersey Semi-Conductor Products, Inc. – Silicon Rectifiers
>£tjnl-(lontLuatoi
no.
20 STERN AVE.
SPRINGFIELD, NEW JERSEY 07081
U8A
Silicon
Rectifiers
TELEPHONE: (973) 378-2922
(212) 227-8008
FAX: (973) 378-8980
MN3260-73.R I
OUniNtD*AWTNO
This product features:
• Choice of stud anode or stud cathode types
• Thermal fatigue resistant
• Lowreverse current
• Great uniformity ofproduct
• High surge curr.ent capabilities
«OII, OHt STEEL
CADMIUM PLATED
Â¥..16 HUT AND ONE
STEEL CADMIUM
IHTtlNAl TOOTH
lOCKWASHtl SUP-
PLIED WITH IACH
UNIT.
RATINGS AND SPECIFICATIONS:11'
1N3260 1N3261 1N3262 1N3283 1N3264 1N3265 1N32G6 1N3267 1N326B 1N3269 1N3270 1N3271 1N3272 1N3273
* Maximum Allowable Repeti-
tive Peak Reverse Voltage,
VllIlM(rep)"»
50 100 150 200 250 300 350 400 500 600 700 800 900 1000
-'Maximum Allowable DC
Blocking Voltage, V»'31
40 80 120 160 200 240 280 320 400 480 560 640 720 800
::: Maximum Allowable Average
Forward Current, IK(AV) (single
phase, 125°C case
temperature)
•*-
160 amperes
'Maximum Allowable Peak
One-Cycle Surge Current,
ITKM(surge) (60 cps single-
phase basis, non-repetitive) •*•
2000 amperes
Minimum Ft Rating
(non-repetitive)
•«—
8,250 amperes- seconds (see Chart 7)
"Maximum Peak Forward
Voltage Drop, VF.M (IT= 160
amps DC, Tc=125°C)
—
1.6 volts
*Maximum Full Load Reverse
Current, Inun (full-cycle
average, 125°C case tem-
perature, single phase)
•*—
12 milliamperes
"Maximum Thermal Resist-
ance, RII,I<: (junction to case) ••—
- 0.3°C/watt —
•Storage Temperature, T.i,
•«—
65°Cto+175°C
'"Operating Temperature, Tj •«—
55°C to +190-C
Stud Torque'"—Maximum
•«—
325 inch-pounds (375 kg-cm)
—Minimum
••—
275 inch-pounds (320 kg-cm)
NOTES: '"Models listed are stud cathode (forward polarity) types. Order 1N32__R for stud anode (reverse polarity)
types. Ratings and specifications are for frequencies from 50 up to 400 cycles/second, except where noted
differently.
'-'Rating assumes a rectifier diode heat sink dissipation of 2.0°C/watt, or less.
'"'Rating assumes a rectifier diode beat sink dissipation of 1.0°C/watt, or less.
'"Use of a silicone grease
between the rectifier base and heat sink is recommended.
'Indicates JEDEC Registration Parameter*.
VI Semi-C'onductors reserves the right to change test conditions, parameter limits nnd package dimensions without notice
Information furnished by NJ Semi-Conductors is believed to he both accurate and reliable at the time of going to press. However SI
Seim-L'oiulutiors av,umes no responsibility for any errors or omissions discovered in its use NJ Semi-tondiicturs enco- -
L u ;<rmcr<; to verify lh.il Jiuashcets are current before placing orders