MJ10048 Datasheet, PDF (1/2 Pages) New Jersey Semi-Conductor Products, Inc. – NPN Silicon Power Darlington Transistor

c⁽/^l
20 STERN AVE.
SPRINGFIELD, NEW JERSEY 07081
U.S.A.
TELEPHONE: [phone]
[phone]
FAX: [phone]
MJ10042
MJ10045
MJ10048
25 KVA ENERGY MANAGEMENT SERIES
SWITCHMODE DARLINGTON TRANSISTORS
25, 60 and 100 Ampere Operating Current
These Darlington transistors are designed for Industrial service
under practical operating environments found in switching high
power inductive loads off 120, 230 and 460 Volt lines.
EMITTER
25, GO, and 100 AMPERE
NPN SILICON
POWER DARLINGTON
TRANSISTOR
260,4BO and 850 VOLTS
260 WATTS
Designer's Data for
"Worst-Gate" Conditions
The Designer's Data Sheet permits
the design of mostciroults enlirelyf rom
the information presented. Umlt dots—
representing device characteristics
boundaries—are given to facilitate
"worst'Case" design.
COLLECTOR
SIVLtl:
PIN I. BASE
2. EMITTER
3. COLLECTOR
4. COLLECTOR
'Emitter-Collector Diode Is a high power diode.
MAXIMUM RATINGS
Mechanical Ratings
Rating
Mounting Torque (To heat sink with 6-32 Screw)
(Note 1)
Lead Torque (Lead to bus with S mm Screw)
(Mole 2)
Per Unit Weight
THERMAL CHARACTERISTICS
Thermal Resistance, Junction to Case.
Value
8.0
20
• 41
0.6
Unit
in.-lb
in, Ib
grams
"C/VV
Mica Insulators available as separate items,
0.003- thick. Motorola Pert Number 14CSB12387BOO3.
Notes:
1. A Belleville washer of 0.281' O.O., O.I 38' I.D., 0.013" thick and 43 pounds flat is
recommended.
2. The maximum penetration of the screw should be limited to 0.60^
3. To adapt the collector and emitter terminals to quick connect terminals, AMP 2BO
Series Faston tab P/N 61499-1 it suggested.
4. The mounting holes of this package are compatible with TO-2O4 (formerly TO-3)
mounting holes.
NOTES:
1. DIMENSIONS A AND B ARE DATUM! AND
T IS BOTH A DATUM SURFACE AND
SEATING PLANE.
1. POSITIONAL TOLERANCE FOR MOUNTING
HOLF.S;
I4100M looioi @|T|A
3. DIMENSIONING AA«CITOLt
ANSI Yli.5,19!!.
4. CONTROLLING DIMENSION: INCH
EXCEPT FOR METRICALLY THREADED
INSERTS.
MILLIMETERS INCHES
.HO.
JIB.
itj
NJ Semi-Conductors reserves the right to change test conditions, parameter limits and package dimensions without
notice. Information furnished by NJ Semi-Conductors is believed to be both accurate and reliable at the time of going
to press. However, NJ Semi-Conductors assumes no responsibility for any errors or omissions discovered in its use
NJ Semi-Conductors encourages customers to verify that datasheets are current before placing orders.
Quality Semi-Conductors