MJ10041 Datasheet, PDF (1/3 Pages) Motorola, Inc – NPN SILICON POWER DARLINGTON TRANSISTOR

tSstni-Conauctoi Lpi
20 STERN AVE.
SPRINGFIELD, NEW JERSEY 07081
U.S.A.
, L/nc.
TELEPHONE: [phone]
[phone]
FAX: [phone]
MJ10041
MJ10044
MJ10047
- 25 kVA ENERGY MANAGEMENT SERIES
SWITCHMODE DARLINGTON TRANSISTORS
25, 50 and 100 Ampere Operating Current
These Darlington transistors are designed for Industrial service
under practical operating environments requiring fast switching
speed for highly efficient systems operating at high frequency
such as inverters, PWM controllers and other high frequency sys-
tems operating from 120, 230 and 460 V lines.
26,50, and 100 AMPERE
NPN SILICON
POWER DARLINGTON
TRANSISTOR
250, 450 and 850 VOLTS
250 WATTS
Designer's Data tor
"Wont-Cue" Conditions
The Designer's Data Sheet permits the design
of most circuits entirely from the Information
presented. Limit data — representing device
characteristic* boundaries — are given to facil-
itate "worst-case" design.
COLLECTOR
SrvLEI:
PIN I. BASE
2. EMITTER
3. COLlECtOR
4. COLLECTOR
'Emitter-Collector Diode Is a fast recovery high power diode.
Note: The 8 ohm resistor f not included In the MJ10044 and MJ10047.
MAXIMUM RATINGS
Mechanical Ratings
Ratinfi
Value
Mounting Torque (To heat sink with 6-32 Screw)
8.0
(Note 1)
Lead Torque (Lead to bus with 5 mm Screw)
20
(Note 2)
Per Unit Weight
41
THERMAL CHARACTERISTICS
[ Thermal Resistance. Junction to Case, R
0.5
Mica Insulators available as aepsrate items.
0.003- thick. Molo.ola Part Number HCSB123B7B003.
Notes:
1. A Belleville wnhtr of 0,28V O.D,, 0.138" I.D., 0.013' thick and 43 pounds flat
Is recommended.
2. Th« maximum penetration o( the screw should ba limited to 0.50*.
3. To sdapt the collector and amlttsr tsrrninals to quick connect terminals, AMP
2EO Series Faslon tsb P/N 6149B-1 il luggeited.
4. The mounting holes of this package are compatible with TO-204 (formerly
TO-3) mounting holes.
Unit
In.-lb
in.-lb
grams
•C/W
NOTES:
1. DIMEN5IONSAANOBABEOATUMSANO
T IS BOTH A DATUM SURFACE AND
SEATING PLANE.
2. POSITIONAL TOLERANCE FOR MOUNTING
HOLES! _
3. DIMENSIONING ANO TOLEBANCING PER
ANSI Y14.5. 1982.
4. CONTROLLING DIMENSION: INCH
EXCEPT FOR METRICALLY THREADED
INSERTS.
MILLIMETERS INCHES
MAX MIN MAX
JOJ1
130. JUL OJ2L OJ1L
-iSL
t.
i
CASE 353-01
NJ Semi-Conductors reserves the right to change test conditions, parameter limits and package dimensions without
notice. Information furnished by N.I Semi-Conductors is believed to be both accurate and reliable at the time of going
to press. However, NJ Semi-Conductors assumes no responsibility for any errors or omissions discovered in its use.
N.I Semi-Conductors encouragescustomers to verify that datasheets are current before placing orders.
Quality Semi-Conductors