ICTE5 Datasheet, PDF (1/2 Pages) Vishay Siliconix – TRANSZORB Transient Voltage Suppressors

tSs.mi-Conclu.cto'i ^Pioducti, Dnc.
20 STERN AVE.
SPRINGFIELD, NEW JERSEY 07081
U.S.A.
TELEPHONE: [phone]
[phone]
FAX: [phone]
TRANSZORB® Transient Voltage Suppressors
ICTE5 thru ICTE18C, 1N6373 thru 1N6386
PRIMARY CHARACTERISTICS
VWM
PpPM
PD
'FSM
Tj max.
5.0 V to 18V
1500W
6.5 W
200 A
175°C
FEATURES
• Glass passivated chip junction
• Available in uni-directional and
bi-directional
• 1500 W peak pulse power capability
with a 10/1000 u.s waveform, repetitive
rate (duty cycle): 0.01 %
• Excellent clamping capability
• Very fast response time
• Low incremental surge resistance
• Solder dip 275 °C max. 10 s, per JESD 22-B106
• AEC-Q101 qualified
TYPICAL APPLICATIONS
Use in sensitive electronics protection against voltage
transients induced by inductive load switching
and lighting on ICs, MOSFET, signal lines of sensor
units for consumer, computer, industrial and
telecommunication.
DEVICES FOR BI-DIRECTION APPLICATIONS
For bi-directional types, use C suffix (e.g. ICTE18C).
Electrical characteristics apply in both directions.
MECHANICAL DATA
Case: Molded epoxy body over passivated junction
Molding compound meets UL 94 V-0 flammability
rating
Terminals: Matte tin plated leads, solderable per
J-STD-002 and JESD 22-B102
E3 suffix meets JESD 201 class 1A whisker test, HE3
suffix meets JESD 201 class 2 whisker test
Polarity: For uni-directional types the color band
denotes cathode end, no marking on bi-directional
types
MAXIMUM RATINGS (TA = 25 °C unless otherwise noted)
PARAMETER
Peak pulse power dissipation with a 10/1000 us waveform '1' (fig. 1)
Peak pulse current with a 10/1000 us waveform (1) (fig. 3)
Power dissipation on infinite heatsink at TL = 75 °C (fig. 8)
Peak forward surge current 8.3 ms single half sine-wave uni-directional only '2*
Maximum instantaneousforward voltage at 100 A (or uni-directional only
Operating junction and storage temperaturerange
Notes
''' Non-repetitive current pulse, per fig. 3 and derated above TA = 25 °C per fig. 2
'2' 8.3 ms single half sine-wave, duty cycle = 4 pulses per minutemaximum
SYMBOL
PPPM
'PPM
PD
'FSM
VF
TJ. TSTG
LIMIT
1500
See next table
6.5
200
3.5
-55to +175
UNIT
W
A
W
A
V
•c
N.I .Semi-C ('Dilution reserves the right to change lest conditions, parameter limits und package dimensions without notice
Information lumuhed by NJ Scmi-Cunducton is believed to he htilh accurate and reliable M the lime of going to press. However '
Scini-t oiidutiiirs iv-uincs mi reiptmsibilify tnr my errors »r uirmsitmi discovered in its u.se NJ Semi-loiidiiitiT* en
ir.ti ii'iTS hi vcrilv ih.it il.'ila^htcij ire current hefbre plnciim urden