NSVS658 Datasheet, PDF (3/4 Pages) New Japan Radio – JRC SAW FILTER

Notice
1. Use this component within operating temperature range. It might not be satisfied with electrical specification
without operating temperature range. When it is used less than -40° C or more than +85° C,it might be a cause of
degradation or destruction of the component.
Even if it endures during a short time, it causes degradation of qualification.
2. When soldering iron is used, solder with the temperature at the tip of soldering iron : 350° C max.,the time of
soldering : 10 seconds max.,the power of soldering iron : 30W max.
3. Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated.
4. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean
this component after confirming that temperature of this component goes down to room temperature.
5. Confirm that there are not any influence for qualification to this component in mounting on PCB when this
component is cleaned.
6. As it might be a cause of degradation of destruction to apply static electricity to this component , do not apply
static electricity or excessive voltage while assembling and measuring. And do not transport this component with
bare hand.
7. As it might be a cause of degradation or destruction to apply D.C. voltage between each terminal, apply D.C.
voltage 3V max. in actual circuit.
Note
1. This specification specifies the quality of this component as a single unit. Make sure that this component is
evaluated and confirmed against this specification when it is mounted to your products.