PLG0E182MCO1 Datasheet, PDF (1/2 Pages) Nichicon corporation – CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS

CONDUCTIVE POLYMER
ALUMINUM SOLID ELECTROLYTIC CAPACITORS
LG Radial Lead Type, Higher Capacitance
series
Higher Capacitance, Low ESR, High ripple current.
Load life of 2000 hours at 105°C.
Radial lead type :
Lead free flow soldering condition correspondence
Adapted to the RoHS directive (2002/95/EC).
LG
Higher
Capacitance
LF
Specifications
Item
Performance Characteristics
Category Temperature Range –55 to +105°C
Rated Voltage Range
2.5 to 16V
Rated Capacitance Range 330 to 3900µF
Capacitance Tolerance
± 20% at 120Hz, 20°C
tan δ
Not more than value of Standard ratings at 120Hz, 20°C
ESR ( 1)
Not more than value of Standard ratings at 100kHz, 20°C
Leakage Current ( 2)
Not more than value of Standard ratings. After 2 minute's application of rated voltage. 20°C
Characteristics of Temperature Z+105°C / Z+20°C 1.25
Impedance Ratio
Z - 55°C / Z + 20°C 1.25
(100kHz)
Endurance
After 2000 hours' application of rated voltage
at 105°C, capacitors meet the specified value
for life characteristics listed at right.
Capacitance change Within ± 20% of initial value ( 3)
tan δ
150% or less of the initial specified value
ESR ( 1)
150% or less of the initial specified value
Leakage current ( 2) Initial specified value or less
Damp Heat
After 1000 hours' application of rated voltage
at 60°C 90%RH, capacitors meet the specified
value for life characteristics listed at right.
Capacitance change
tan δ
ESR ( 1)
Leakage current ( 2)
Within ± 20% of initial value ( 3)
150% or less of the initial specified value
150% or less of the initial specified value
Initial specified value or less
Resistance to
Soldering Heat
To comply with recommended conditions for
reflow soldering. Pre-heating shall be done
at 150 to 200°C and for 60 to 180 sec.
Peak temp. is 265°C, within 10 sec.
Measurement for solder temperature profile
shall be made at a point on the terminal
nearest where the terminals protrude through
the soldering side of PC board.
Capacitance change Within ± 10% of initial value ( 3)
tan δ
130% or less of the initial specified value
ESR ( 1)
130% or less of the initial specified value
Leakage current ( 2) Initial specified value or less
Marking
Navy blue print on the case top.
( 1) ESR measurements should be made at a point on the terminal nearest the end seal of the capacitor.
( 2) Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes
at the temperature of 105°C.
( 3) Initial value : The value before test of examination of resistance to soldering.