PLE0E561MCO1 Datasheet, PDF (1/2 Pages) Nichicon corporation – CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS

CONDUCTIVE POLYMER
ALUMINUM SOLID ELECTROLYTIC CAPACITORS
LE Ultra Low ESR
series
Ultra Low ESR, High ripple current.
Load life of 2000 hours at 105°C.
Radial lead type :
Lead free flow soldering condition correspondence
Adapted to the RoHS directive (2002/95/EC).
LE
LF ^{Low ESR}
Specifications
Item
Performance Characteristics
Category Temperature Range –55 ~ +105°C
Rated Voltage Range
2.5 ~ 6.3V
Rated Capacitance Range 470 ~ 1500µF
Capacitance Tolerance
± 20% at 120Hz, 20°C
tan δ
Not more than value of Standard ratings at 120Hz, 20°C
ESR ( 1)
Not more than value of Standard ratings at 100kHz, 20°C
Leakage Current ( 2)
Not more than value of Standard ratings. After 2 minute's application of rated voltage. 20°C
Characteristics of Temperature Z+105°C / Z+20°C 1.25
Impedance Ratio
Z - 55°C / Z + 20°C 1.25
(100kHz)
Endurance
After 2000 hours' application of rated voltage
at 105°C, capacitors meet the specified value
for life characteristics listed at right.
Capacitance change Within ± 20% of initial value ( 3)
tan δ
150% or less of the initial specified value
ESR ( 1)
150% or less of the initial specified value
Leakage current ( 2) Initial specified value or less
Damp Heat
After 1000 hours' application of rated voltage
at 60°C 90%RH, capacitors meet the specified
value for life characteristics listed at right.
Capacitance change
tan δ
ESR ( 1)
Leakage current ( 2)
Within ± 20% of initial value ( 3)
150% or less of the initial specified value
150% or less of the initial specified value
Initial specified value or less
Resistance to
Soldering Heat
To comply with recommended conditions for
reflow soldering. Pre-heating shall be done
at 150 ~ 200°C and for 60 ~ 180 sec.
Peak temp. is 265°C, within 10 sec.
Measurement for solder temperature profile
shall be made at a point on the terminal
nearest where the terminals protrude through
the soldering side of PC board.
Capacitance change Within ± 10% of initial value ( 3)
tan δ
130% or less of the initial specified value
ESR ( 1)
130% or less of the initial specified value
Leakage current ( 2) Initial specified value or less
Marking
Navy blue print on the case top.
( 1) ESR measurements should be made at a point on the terminal nearest the end seal of the capacitor.
( 2) Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes
at the temperature of 105°C.
( 3) Initial value : The value before test of examination of resistance to soldering.