NSSW157BT Datasheet, PDF (6/17 Pages) NICHIA CORPORATION – Pb-free Reflow Soldering Application, Built-in ESD Protection Device

SOLDERING
NICHIA STS-DA1-2682A <Cat.No.130306>
• Recommended Reflow Soldering Condition(Lead-free Solder)
1 to 5°C per sec
Pre-heat
180 to 200°C
60sec Max
Above 220°C
260°C Max
10sec Max
• Recommended Hand Soldering Condition
Temperature
350°C Max
Soldering Time
3sec Max
120sec Max
● Recommended Soldering Pad Pattern
● Recommended Metal Solder Stencil Aperture
0.8
2.4
0.8
0.6
1.66
0.5 0.64 0.6
0.6
1.56
0.7 0.54 0.6
(単位 Unit: mm)
* This LED is designed to be reflow soldered on to a PCB. If dip soldered, Nichia cannot guarantee its reliability.
* Reflow soldering must not be performed more than twice. Hand soldering must not be performed more than once.
* Avoid rapid cooling. Ramp down the temperature gradually from the peak temperature.
* Nitrogen reflow soldering is recommended. Air flow soldering conditions can cause optical degradation,
caused by heat and/or atmosphere.
* Since the silicone used in the encapsulating resin is soft, do not press on the encapsulant resin.
Pressure can cause nicks, chip-outs, encapsulant delamination and deformation, and wire breaks, decreasing reliability.
* Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable,
a double-head soldering iron should be used.
It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
* When soldering, do not apply stress to the LED while the LED is hot.
5