NSSM032 Datasheet, PDF (6/17 Pages) NICHIA CORPORATION – SPECIFICATIONS FOR FULL COLOR LED

SOLDERING
NICHIA STS-DA1-1857D <Cat.No.130605>
• Recommended Reflow Soldering Condition(Lead-free Solder)
1 to 5°C per sec
Pre-heat
180 to 200°C
60sec Max
Above 220°C
260°CMax
10sec Max
• Recommended Hand Soldering Condition
Temperature
350°C Max
Soldering Time
3sec Max
120sec Max
● Recommended Soldering Pad Pattern
1.55
2.9
1.55
6
(単位 Unit: mm)
* This LED is designed to be reflow soldered on to a PCB. If dip soldered, Nichia cannot guarantee its reliability.
* Reflow soldering must not be performed more than twice. Hand soldering must not be performed more than once.
* Avoid rapid cooling. Ramp down the temperature gradually from the peak temperature.
* Nitrogen reflow soldering is recommended. Air flow soldering conditions can cause optical degradation,
caused by heat and/or atmosphere.
* Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable,
a double-head soldering iron should be used.
It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
* When soldering, do not apply stress to the LED while the LED is hot.
* When using a pick and place machine, choose an appropriate nozzle for this product.
* This product can differ in optical characteristics depending on the number of reflow cycles.
In a single display, only LEDs with same number of reflow cycles should be used regardless of the application type,
such as rental and/or permanent installations.
* The recommended soldering pad pattern is designed for attachment of the LED without problems.
When precise mounting accuracy is required, such as high-density mounting, ensure that the size and shape of the pad
are suitable for the circuit design.
* Consider factors such as the reflow soldering temperature, hand soldering temperature, etc. when choosing the solder.
* When flux is used, it should be a halogen free flux. Ensure that the manufacturing process is not designed in a manner
where the flux will come in contact with the LEDs.
* Make sure that there are no issues with the type and amount of solder that is being used.
5