PXI-2564 Datasheet, PDF (2/3 Pages) National Instruments Corporation – 16-Channel, 5 A SPST (Form A) Relays

16-Channel, 5 A SPST (Form A) Relays
Specifications
Relay Characteristics
Number of channels......................................... 16
Relay type......................................................... SPST, normally open, nonlatching
Maximum switching voltage
Channel-to-channel ................................... 150 VDC, 150 VAC
Channel-to-ground..................................... 150 VDC, 150 VAC, CAT II
Maximum switching current ............................ 5 A
Maximum carry current.................................... 5 A
Simultaneous channels at maximum current..... 16
Maximum AC switching power........................ 750 VA
Maximum DC switching power
150 W at 30 V
30 W at 150 V
DC path resistance
Initial.......................................................... <100 mΩ
End of life .................................................. 250 mΩ
Minimum switching capacity........................... 10 mA or 5 VDC
Dynamic Characteristics
Maximum cycle speed ..................................... 45 cycles/s
Relay operate time
Maximum................................................... 10.4 ms
Expected relay life
Mechanical ................................................ 5x10⁷ cycles
Electrical
Full load .............................................. 1x10⁵ cycles
Physical
Relay type......................................................... Armature, nonlatching
Relay contact material ..................................... Gold flash over silver alloy
I/O connector.................................................... 37-pin D-Sub, male
Dimensions....................................................... Single PXI slot, 3U
Environment
Operating temperature..................................... 0 to 55 °C
Storage temperature ........................................ -20 to 70 °C
Relative humidity ............................................. 5 to 85% noncondensing
Pollution degree ............................................... 2
Approved at altitudes up to 2000 m
Safety
This product is designed to meet the requirements of the following standards of safety for electrical
equipment for measurement, control, and laboratory use:
• IEC 61010-1, EN 61010-1
• UL 61010-1
• CAN/CSA C22.2 No. 61010-1
Electromagnetic Compatibility
CE, C-Tick, and FCC Part 15 (Class A) Compliant
Emissions.......................................................... EN 55011 Class A at 10 m
FCC ................................................................... Part 15A above 1 GHz
Immunity........................................................... EN 61326:1997 +A2:2001, Table 1
CE Compliance
This product meets the essential requirements of applicable European Directives, as amended for
CE Marking, as follows:
Low-Voltage Directive (safety)......................... 73/23/EEC
Electromagnetic Compatibility
Directive (EMC) ................................................ 89/336/EEC
2 National Instruments • Tel: [phone] • Fax: [phone] • [e-mail] • ni.com