UPG2030TK_1 Datasheet, PDF (3/11 Pages) NEC – L, S-BAND SPDT SWITCH

μPG2030TK
ELECTRICAL CHARACTERISTICS
(TA = +25°C, Vcont = 2.8 V/0 V, DC cut capacitors = 56 pF, unless otherwise specified)
Parameter
Insertion Loss 1
Insertion Loss 2
Insertion Loss 3
Isolation 1
Isolation 2
Input Return Loss
Output Return Loss
0.1 dB Gain Compression
Input Power ^Note
Switch Control Current
Switch Control Speed
Symbol
Test Conditions
LINS1 f = 0.5 to 1.0 GHz
LINS2 f = 1.0 to 2.0 GHz
LINS3 f = 2.0 to 2.5 GHz
ISL1 f = 0.5 to 2.0 GHz
ISL2 f = 2.0 to 2.5 GHz
RLin f = 0.5 to 2.5 GHz
RLout f = 0.5 to 2.5 GHz
Pin (0.1 dB) f = 2.0 GHz
f = 2.5 GHz
Icont No signal
tSW
MIN.
−
−
−
23
20
15
15
+25.5
+25.5
−
−
TYP.
0.25
0.30
0.35
27
24
20
20
+27.0
+27.0
4
50
MAX.
0.45
0.50
0.55
−
−
−
−
−
−
20
500
Unit
dB
dB
dB
dB
dB
dB
dB
dBm
dBm
μA
ns
Note Pin (0.1 dB) is measured the input power level when the insertion loss increases more 0.1 dB than that of linear
range.
STANDARD CHARACTERISTICS FOR REFERENCE
(TA = +25°C, Vcont = 2.8 V/0 V, DC cut capacitors = 56 pF, unless otherwise specified)
Parameter
1 dB Gain Compression
Input Power ^Note
Symbol
Test Conditions
Pin (1 dB) f = 2.0 GHz
MIN.
−
TYP.
+30.0
MAX.
−
Unit
dBm
Note Pin (1 dB) is measured the input power level when the insertion loss increases more 1 dB than that of linear
range.
Caution This device is used it is necessary to use DC cut capacitors.
The value of DC cut capacitors should be chosen to accommodate the frequency of operation,
bandwidth, switching speed and the condition with actual board of your system. The range of
recommended DC cut capacitor value is less than 100 pF.
Data Sheet PG10409EJ03V0DS
3