UPG2030TK Datasheet, PDF (3/9 Pages) NEC – NECs 1 W ULTRA SMALL SPDT SWITCH

UPG2030TK
ELECTRICAL CHARACTERISTICS
(TA = +25°C, Vcont = 2.8V/0 V , DC blocking capacotors = 56 pF, unless otherwise specified)
PARAMETER
Insertion Loss 1
Insertion Loss 2
Insertion Loss 3
Isolation 1
Isolation 2
Input Return Loss
Output Return Loss
0.1 dB Gain Compression
Input Power ^Note
Switch Control Current
Switch Control Speed
SYMBOL
TEST CONDITIONS
LINS1 f = 0.5 to 1.0 GHz
LINS2 f = 1.0 to 2.0 GHz
LINS3 f = 2.0 to 2.5 GHz
ISL1 f = 0.5 to 2.0 GHz
ISL2 f = 2.0 to 2.5 GHz
RLin f = 0.5 to 2.5 GHz
RLout f = 0.5 to 2.5 GHz
Pin (0.1 dB) f = 2.0 GHz
f = 2.5 GHz
Icont
No signal
tSW
MIN.
−
−
−
23
20
15
15
+25.5
+25.5
−
−
TYP.
0.25
0.30
0.35
27
24
20
20
+27.0
+27.0
4
50
MAX.
0.45
0.50
0.55
−
−
−
−
−
−
20
500
UNIT
dB
dB
dB
dB
dB
dB
dB
dBm
dBm
μA
ns
Notes Pin (0.1 dB) is the measured input power level when the insertion loss increases 0.1 dB more
than that of linear range.
STANDARD CHARACTERISTICS FOR REFERENCE
(TA = +25°C, Vcont = 2.8 V/0 V, DC blocking capacitors = 56 pF, unless otherwise specified)
PARAMETER
1 dB Gain Compression
Input Power ^Note
SYMBOL
TEST CONDITIONS
Pin (1 dB) f = 2.0 GHz
MIN.
−
TYP.
+30.0
MAX.
−
UNIT
dBm
Notes Pin (1 dB) is the measured input power level when the insertion loss increases 1 dB more
than that of linear range.
Caution It is necessary to use DC blocking capacitors with this device.
The value of DC blocking capacitors should be chosen to accommodate the frequency of operation, bandwidth,
switching speed and the condition with the actual board of your system. The range of recommended
DC blocking capacitor value is less than 100 pF for frequencies above 0.5 GHz, and 1,000 pF for frequencies
below 0.5 GHz.