MU9C3640L Datasheet, PDF (18/22 Pages) MUSIC Semiconductors – LIST-XL Family

LIST-XL Family
Electrical
ELECTRICAL
Supply Voltage
Voltage on all other pins
Temperature under bias
Storage Temperature
DC Output Current
Absolute Maximum Ratings
-0.5 to 4.6 Volts
-0.5 to VCC +0.5 Volts
(-2 Volts for 10 ns, measured at the 50% point)
-55° C to 125° C
-55° C to 125° C
20 mA (per output, one at a time, one second
duration)
Stresses exceeding those listed under Absolute
Maximum Ratings may induce failure. Exposure to
absolute maximum ratings for extended periods may
reduce reliability. Functionality at or above these
conditions is not implied.
All voltages referenced to GND.
Symbol
VCC
VIH
VIL
TA
Parameter
Operating supply voltage
Input voltage logic 1
Input voltage logic 0
Ambient operating temperature
Commercial
Industrial
Min. Typical
3.0 3.3
2.0
-0.5
0
-40
Max.
3.6
VCC + 0.5
0.8
70
85
Units
Volts
Volts
Volts
°C
°C
Notes
1, 2
Still air
Table 12: Operating Conditions (Voltages referenced to GND at the device pin)
Notes:
1. 1.0 Volts for a duration of 10 ns measured at the 50% amplitude points for Input-only lines (see Figure 5 on page 19).
2. Common I/O lines are clamped, so that signal transients can not fall below -0.5 Volts
.
Symbol
ICC
ICC(SB)
VOH
VOL
Parameter
Average Power Supply Current
Stand-by Power Supply Current
Output voltage logic 1
Output voltage logic 0
IIZ
Input leakage current
IOZ
Output leakage current
Min. Typical
20
2.4
Others
-2
/RESET
6
9
-10
Max.
30
2
0.4
+2
12
10
Table 13: DC Electrical Characteristics
Units
mA
mA
Volts
Volts
μA
Kohms
μA
Notes
tELEL = tELEL(min);9
/E = HIGH
IOH = -2.0 mA
IOL = 4.0 mA
VSS ≤ VIN ≤ VCC
VIN = 0 V
VSS ≤ VOUT ≤ VCC
DQN = High Impedance
Symbol Parameter
CIN Input capacitance
COUT Output capacitance
Table 14: Capacitance
Max.
6
7
Units
pF
pF
Notes
f = 1 MHz, VIN = 0V
f = 1 MHz, VOUT = 0V
Input Signal Transitions
0.0 Volts to 3.0 Volts
Input Signal Rise Time
< 3 ns
Input Signal Fall Time
< 3 ns
Input Timing Reference Level 1.5 Volts
Output Timing Reference Level 1.5 Volts
Table 15: AC Test Conditions
18
Rev. 3.1