DSS6NC52A221T51B Datasheet, PDF (5/5 Pages) Murata Manufacturing Co., Ltd. – Leaded EMIFIL (Three-terminal Capacitor type) Small Type

Noise Suppression Products/EMI Suppression Filters > Leaded EMIFILr (Three-terminal Capacitor type) > Small Type
Data Sheet
5
Continued from the preceding page.
Notice
o Storage and Operating Conditions
<Operating Environment>
2. Products should be used at rated voltage or less and
1. Do not use products in a chemical atmosphere such
rated current or less.
as chlorine gas, acid or sulfide gas.
3. Products should not be applied for the absorption of
2. Do not use products near water, oil or organic
surges that have large energy (e.g., induced lightning
solvents. Avoid environments where dust or dirt may
surges, switching surges) because it is designed for the
adhere to the product.
absorption of electrostatic surges (VFR3V).
<Storage and Handling Requirements>
4. Electrostatic testing should be done on the following
1. Storage Period
conditions (VFR3V).
Use the products within 12 months after delivery.
Ns;#2s6² ]² < 8.0 x10⁵
Solderability should be checked if this period is
n: Times applied
exceeded.
C: Charging Capacitance (pF)
2. Storage Conditions
V: Testing Voltage (kV)
(1) Storage temperature: -10 to 40 degrees C
R: Charging Resistance (Ω)
Relative humidity: 15 to 85%
Avoid sudden changes in temperature and humidity.
(2) Do not store products in a chemical atmosphere
o Soldering and Mounting
1. Washing
such as chlorine gas, acid or sulfide gas.
Failure and degradation of a product are caused
(3) When restoring taping type (BL01RN1A1F1J),
please attach the spacer between the flanges of the
reel. The spacer is corrugated paper that is attached
by the washing method. When you wash in conditions
that are not in the mounting information, please contact
Murata engineering.
when shipping.
2. Soldering
<Using EMIGUARDr effectively>
1. Terminal (with mark) should be properly connected to
Reliability decreases with improper soldering
methods. Please solder by the standard soldering
the line of incoming electrostatic surge. (There is
conditions shown in the mounting information.
polarity.) Otherwise, no effect in ESD suppression can
3. Other
be expected (VFR3V).
Noise suppression levels resulting from Murata's
Example of input terminal Example of output terminal
EMI suppression filters EMIFILr may vary, depending
on the circuits and ICs used, type of noise, mounting
Incoming
Electrostatic Surges
Incoming
Electrostatic Surges
pattern, lead wire length, mounting location, and other
operating conditions. Be sure to check and confirm in
advance the noise suppression effect of each filter, in
actual circuits, etc. before applying the filter in a
commercial-purpose equipment design.
oThis data sheet is applied for Lead EMIFILr Capacitor Type used for General Electronics equipment for your design.
!Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it
may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
2013.5.9
http://www.murata.com/