LQH31MNR15K03D Datasheet, PDF (3/3 Pages) Murata Manufacturing Co., Ltd. – Chip Inductor (Chip Coil) for General Use Wire Wound Type LQH31M Series

Continued from the preceding page.
I Q-Frequency Characteristics (Typ.)
100
80
100µH
10µH
1µH
60
40
20
0
0.1
1
10
Frequency (MHz)
Inductors (Coils) > Chip Inductor (Chip Coil) > for General Use Wire Wound Type
Data Sheet
3
I Inductance-Current Characteristics (Typ.)
1000
100
100µH
33µH
10µH
10
1.0µH
1
0.1
100
1
10
100
1000
Current (mA)
I !Caution/Notice
!Caution (Rating)
Do not use products beyond the rated current as
this may create excessive heat.
Notice
Solderability of Tin plating termination chip might be
deteriorated when low temperature soldering profile
where peak solder temperature is below the Tin melting
point is used. Please confirm the solderability of Tin
plating termination chip before use.
o This data sheet is applied for CHIP INDUCTORS (CHIP COILS) used for General Electronics equipment for your design.
! Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
2010.9.9
http://www.murata.com/