L0075S0092LQM21N Datasheet, PDF (2/2 Pages) Murata Manufacturing Co., Ltd. – Chip Inductor (Chip Coil) for General Use Multilayer Type

Continued from the preceding page.
c Q-Frequency Characteristics (Typ.)
100
1.0μH
80
1.8μH
0.1μH
4.7μH
0.22μH
60
40
0.18μH
20
0
1
10
100
Frequency (MHz)
Inductors (Coils) > Chip Inductor (Chip Coil) > for General Use Multilayer Type
Data Sheet
2
c Inductance-Current Characteristics (Typ.)
100
10
4.7μH
1.8μH
1
1.0μH
0.82μH
0.22μH
0.10μH
0.1
1000
0.01
1
10
100
Current (mA)
1000
c !Caution/Notice
!Caution (Rating)
Do not use products beyond the rated current as
this may create excessive heat.
Notice
Solderability of Tin plating termination chip might be
deteriorated when low temperature soldering profile
where peak solder temperature is below the Tin melting
point is used. Please confirm the solderability of Tin
plating termination chip before use.
oThis data sheet is applied for CHIP INDUCTORS (CHIP COILS) used for General Electronics equipment for your design.
!Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it
may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
2012.11.8
http://www.murata.com/