SF2202E-1 Datasheet, PDF (1/5 Pages) Murata Manufacturing Co., Ltd. – 2017.5 MHz SAW Filter

Preliminary
• Surface Mount 3.0 x 3.0 x 1.3 mm Package
• Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating
Input Power Level
DC Voltage on any Non-ground Terminal
Operating Temperature Range
Storage Temperature Range
Solder Reflow Temperature, 10 seconds, 5 cycles maximum
Pb
Value
10
3
-40 to +95
-40 to +95
260
Units
dBm
V
°C
°C
°C
SF2202E-1
2017.5 MHz
SAW Filter
Electrical Characteristics
Characteristic
Sym Min(-40~95°C)
Center Frequency
F_C
Insertion Loss, 2010 to 2025 MHz
IL
Amplitude Ripple, 2010 to 2025 MHz
VSWR, 2010 to 2025
Group Delay Ripple, 2010 to 2025 MHz
Attenuation, Referenced to 0 dB
1700 to 1785 MHz
40
1800 to 1860 MHz
45
1920 to 1980 MHz
30
2045 to 2070 MHz
6
2070 to 2085 MHz
15
2170 to 4000 MHz
30
Source Impedance
Z_S
Load Impedance
Z_L
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
Typ
2017.5
3.1
0.4
1.3:1
9
Max(-40~85°C)
4.2
1.4
30
SM3030-6
(-40~95°C)
4.5
1.8
2.5:1
30
Units
MHz
dB
dB_P-P
ns_P-P
50
51
37
dB
33
54
33
50
Ω
50
SM3030-6 3.0 x 3.0 mm Nominal Footprint
947, YWWS
500 Pieces/Reel
3000 Pieces/Reel
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc
www.RFM.com E-mail: [e-mail]
©2013 by RF Monolithics, Inc.
Page 1 of 5
SF2202E-1 6/28/13