SF2189A Datasheet, PDF (1/6 Pages) RF Monolithics, Inc – 140 MHz SAW Filter

Preliminary
• Precision IF SAW Filter
• Hermetic 13.3 x 6.5 mm Surface-mount Case
• Complies with Directive 2002/95/EC (RoHS)
Pb
SF2189A
140 MHz
SAW Filter
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Maximum DC Voltage between any Two Terminals
Storage Temperature Range in Tape and Reel
Suitable for Lead-free Soldering - Maximum Soldering Profile
Electrical Characteristics
Characteristic
Center Frequency
Minimum Insertion Loss
1 dB Bandwidth
3 dB Bandwidth
35 dB Bandwidth
Passband Amplitude Ripple, 80% of 3 dB Bandwidth
Passband Group Delay Ripple, 80% of 3 dB Bandwidth
Passband Absolute Group Delay
Passband Phase Linearity, 80% of 3 dB Bandwidth
Operating Temperature
Frequency Temperature Coefficient
Source Impedance
Load Impedance
Case Style
Lid Symbolization (YY = year, WW = week)
Value
Units
+10
dBm
3
VDC
-40 to +85
°C
260°C for 30 s
SM13365-12
Sym
F_C
IL_MIN
BW₁
BW₃
BW₃₅
Notes
Min
1
1
1
30.0
1
32.0
1
1, 2, 3
1, 2, 3
1,2,3
1, 2, 3
1
-20
Typ
140
11.3
33.0
35.0
42.4
0.6
50
0.55
5
-94
50
50
Max
13.0
44.0
1.2
120
14
+80
SM13365-12 13.3 x 6.5 mm Nominal Footprint
RFM SF2189A YYWW
Units
MHz
dB
MHz
MHz
MHz
dB_P-P
ns_P-P
µs
deg_P-P
°C
ppm/°C
ohm
ohm
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. Part to part absolute delay measurement records the absolute delay mean across 1 dB passband.
5. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes.”
6. The design, manufacturing process, and specifications of this filter are subject to change.
7. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
8. US and international patents may apply.
www.RFM.com E-mail: [e-mail]
©2009 by RF Monolithics, Inc.
Page 1 of 6
SF2189A - 7/1/09