SF2170D Datasheet, PDF (1/6 Pages) RF Monolithics, Inc – 165 MHz SAW Filter

• Low Insertion Loss
• 3.8 X 3.8 X 1.0 mm Surface Mount Case
• Single-Ended Input/Output
• Complies with Directive 2002/95/EC (RoHS) Pb
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Maximum DC Voltage between any 2 Terminals
Storage Temperature Range
Suitable for Lead-free Soldering - Maximum Soldering Profile
Value
Units
+10
dBm
30
VDC
-40 to +85
°C
260°C for 30 s
SF2170D
165 MHz
SAW Filter
Electrical Characteristics
Characteristic
Center Frequency
Source Impedance to Matching Network (single ended)
Load Impedance to Matching Network (single ended)
Passband Width
Rejection Referenced from Minimum Insertion Loss:
10 MHz to 110 MHz
127 MHz to 149 MHz
190 to 210 MHz
210 to 450 MHz
Maximum Insertion Loss
Insertion Loss Variation over -40 to 85 °C
Amplitude Variation over 20 MHz Passband
Group Delay Variation over 20 MHz Passband
Absolute Group Delay at fo
Input/Output Return Loss into Matching over 20 MHz BW
Operating Temperature
Sym
f_O
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity Reel Size 7 Inch
Reel Size 13 Inch
SM3838-6
Notes
Min
Typ
Max
1
165
50
50
20
22
35
40
10
15
30
40
40
45
9
10
1
1.0
1.5
40
80
0.33
6
8
-40
+85
SM3838-6 3.8 x 3.8 mm Nominal Footprint
865, YWWS
1000 Pieces/Reel
3000 Pieces/Reel
Units
MHz
Ω
Ω
MHz
dB
dB
dB
dB_p-p
ns_p-p
µs
dB
°C
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. The design, manufacturing process, and specifications of this filter are subject to change.
5. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
6. US and international patents may apply.
7. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
www.RFM.com E-mail: [e-mail]
©2009 by RF Monolithics, Inc.
Page 1 of 6
SF2170D - 4/29/09