SF2065C Datasheet, PDF (1/5 Pages) Murata Manufacturing Co., Ltd. – 743.00 MHz SAW Filter

• Low Insertion Loss
• 5.0 x 5.0 x 1.7 mm Suface-mount Case
• No Matching Required
• Complies with Directive 2002/95/EC (RoHS)
Pb
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Maximum DC Voltage on any Non-ground Terminal
Storage Temperature Range in Tape and Reel
Suitable for Lead-free Soldering - Maximum Soldering Profile
Electrical Characteristics
Characteristic
Center Frequency
Insertion Loss, 740 to 746 MHz
Amplitude Ripple, 740 to 746 MHz
Attenuation Referenced to 0 dB:
0.3 to 643 MHz
643 - 693 MHz
693 - 720 MHz
766 - 793 MHz
793 - 843 MHz
843 - 1000 MHz
1000 - 1500 MHz
Group Delay Deviation
Source/Load Impedance (no matching required)
Operating Temperature Range
Case Style
Lid Symbolization (Y=year, WW=week S=shift)
SF2065C
Value
Units
+10
dBm
30
VDC
-40 to +85
°C
260°C for 30 s
743.00 MHz
SAW Filter
SM5050-8
Sym Notes
Min
f_C
Typ
743.00
2.6
0.7
Max
4.5
43
49
40
46
35
42
35
45
40
49
38
45
25
33
45
50
T_A
1
-10
+60
SM5050-8 5 X 5 mm Nominal Footprint
551 YWWS
Units
MHz
dB
dB_P-P
dB
ns_P-P
Ω
°C
50
pin 2
pin 6
SAW Filter
TOP VIEW
50
pins 1, 3, 4, 5, 7, 8
RF IC
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
3. The design, manufacturing process, and specifications of this filter are subject to change.
4. US and international patents may apply.
5. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
www.RFM.com E-mail: [e-mail]
©2008-2010 by RF Monolithics, Inc.
Page 1 of 5
SF2065C - 6/14/10